DELL logoDell™ C5522QT/C6522QT RS232
External Control

Application

This document defines the communication method for control of the Dell LCD display C5522QT /
C6522QT when using an external controller.

Connectors and wiring

2.1 RS-232C Remote Access
Connector: 9-pin D-Sub
Cable: Straight cable or null modem cable

DELL C5522QT 4K Interactive Touch Monitor - wiring

RS232 Pin Assignment (Facing Display)

DELL C5522QT 4K Interactive Touch Monitor - wiring1

This display uses RXD, TXD, and GND lines for RS-232 control.
DELL C5522QT 4K Interactive Touch Monitor - iconNote 1: The RS232 cable is not provided by Dell.
2.2 LAN control
Connector: RJ-45 10/100 BASE-T
Cable: Category 5 or higher LAN cable

DELL C5522QT 4K Interactive Touch Monitor - control

DELL C5522QT 4K Interactive Touch Monitor - iconNote 2: The LAN cable is not provided by Dell

Communication Parameter

3.1 RS-232C Remote access

1InterfaceRS-232C
2Baud rate9600bps
3Data length8bits
4ParityNone
5Stop bit1 bit

3.2 LAN control

1Communication systemTCP/IP (Internet protocol suite)
2InterfaceEthernet
3Communication layerTransport layer (TCP)
Using the payload of a TCP segment.
4IP addressIf you need to change, Default: 10.0.50.100
Please refer “Dell Web Management for Displays” section on the User’s manual.
5Port No.4661 (Fixed)

Communication Format

Control Command Syntax
[H0][H1][Len][R/W][Cmd][Data0]…[DataN][Chk] [H0] = 0x37
[H1] = 0x51
[Len] = Length
[R/W] = Read/Write
Read = 0xEB
Write = 0xEA
[Cmd] = Command
[Data0]…[DataN] = Data0~N
[Chk] = Check Sum
Reply Command Syntax
[H2][H3][Len][Reply][RC][Cmd][Data0]…[DataN][Chk] [H2] = 0x6F
[H3] = 0x37
[Len] = Length
[Reply] = Reply (0x02)
[RC] = Result Code
0 = Success
1 = Timeout
2 = Parameters Error
3 = Not connected
4 = Other Failure
[Cmd] = Command
[Data0]…[DataN] = Data0~N
[Chk] = Check Sum
Example: Get Display Name
[From PC to Display] = 37, 51, 02, EB, 01, 8E
[From Display to PC] = 6F, 37, 0F, 02, 00, 01, 44, 65, 6C, 6C, 20, 43, 37, 35, 32, 30, 51, 54, 13
CheckSum calculation
Xor byte by byte from first byte to the end of the command data stream.

DELL C5522QT 4K Interactive Touch Monitor - calculation

Control Commands List

DELL C5522QT 4K Interactive Touch Monitor - table

DELL C5522QT 4K Interactive Touch Monitor - table1

Information in this document is subject to change without notice.
© 2020 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
December 2020 Rev. A00

Documents / Resources

DELL C5522QT 4K Interactive Touch Monitor [pdf] User Guide
C5522QT, C6522QT RS232, 4K Interactive Touch Monitor

References

Leave a comment

Your email address will not be published. Required fields are marked *