TEC TC-760LC

TEC TC-760LC MM/MC Phono Preamplifier Bedienungsanleitung

Model: TC-760LC

1. Einleitung

This manual provides detailed instructions for the proper installation, operation, and maintenance of your TEC TC-760LC MM/MC Phono Preamplifier. The TC-760LC is designed to boost the output of both Moving Magnet (MM) and Moving Coil (MC) phono cartridges, allowing connection to an audio amplifier or receiver that lacks a dedicated phono input. This unit ensures your turntable's signal is correctly amplified and equalized to the RIAA standard for optimal sound reproduction.

2. Sicherheitshinweise

Bitte lesen und verstehen Sie die folgenden Sicherheitsvorkehrungen, bevor Sie das Gerät in Betrieb nehmen:

  • Ensure the power adapter is connected to a compatible power outlet with the correct voltage.
  • Das Gerät darf keiner Feuchtigkeit, keinem Regen und keinen extremen Temperaturen ausgesetzt werden.
  • Avoid placing the unit near heat sources, such as radiators, or in direct sunlight.
  • Versuchen Sie nicht, das Gehäuse zu öffnen.asinSie können das Gerät auch selbst warten. Alle Wartungsarbeiten sollten qualifiziertem Fachpersonal überlassen werden.
  • Disconnect power from the wall outlet before making any connections or disconnections to prevent electrical shock or damage to equipment.
  • Halten Sie das Gerät von Kindern und Haustieren fern.

3. Packungsinhalt

Verify that all the following items are present in your product package:

  • TEC TC-760LC Phono Preamplifier (Schwarz)
  • Premium AC Adaptor (Magellan Switching Adapter)
  • RCA-Kabel
  • Miniplug Adaptor
Magellan Switching Adapter for TEC TC-760LC

Image: Included AC Power Adapter. This Magellan switching adapter provides 12V at 1A output and is designed for use with the phono preampschwerer.

4. Produktüberschreitungview

4.1. Hauptmerkmale

  • In schwarzer Ausführung erhältlich.
  • Total harmonic distortion: 0.005%.
  • RIAA frequency response: 20Hz-20,000Hz +/- 0.5dB.
  • Signal-to-noise ratio: 82dB (MM) / 85dB (MC).
  • Gain: 38dB (MM) / 58dB (MC).
  • Selectable high range (100 ohm) / low range (20 ohm) MC input impedance.

4.2. Bedienelemente auf der Vorderseite

Front view of TEC TC-760LC Phono Preampschwerer

Image: Front panel of the TEC TC-760LC Phono Preamplifier. Shows the Power indicator, MC/MM selector switch, and Level Control knob.

  • Betriebsanzeige: An LED that illuminates when the unit is powered on.
  • MC/MM Select Switch: A toggle switch to select between Moving Coil (MC) and Moving Magnet (MM) input modes. Ensure this matches your turntable cartridge type.
  • Niveauregulierung: A rotary knob to adjust the output volume of the preampschwerer.

4.3. Anschlüsse auf der Rückseite

Hinteren view of TEC TC-760LC Phono Preampschwerer

Image: Rear panel of the TEC TC-760LC Phono Preamplifier. Displays RCA output jacks, MM input jacks (47kΩ), MC input jacks (20Ω, 100Ω), a ground terminal, and the DC power input.

  • OUTPUT (Receiver/Amp): RCA stereo output jacks (Left and Right) for connecting to your amplifier or receiver's line-level input (e.g., AUX, CD, Tuner).
  • INPUTS (MM): RCA stereo input jacks (Left and Right) specifically for Moving Magnet cartridges. The input impedance is fixed at 47kΩ.
  • INPUTS (MC): RCA stereo input jacks (Left and Right) for Moving Coil cartridges. These inputs feature selectable impedance options: 20Ω and 100Ω, typically chosen via small switches near the inputs.
  • Erdungsklemme: A screw terminal to connect your turntable's ground wire. This connection is crucial for minimizing hum and noise.
  • Gleichstromeingang: A jack for connecting the included AC power adapter.

5. Einrichtung

Follow these steps to correctly set up your TEC TC-760LC Phono PreampReiniger:

  1. Power Off All Equipment: Before making any connections, ensure your turntable, amplifier/receiver, and the phono preamplifier are all powered off and unplugged from the wall outlet.
  2. Connect Turntable to PreampReiniger:
    • Connect the RCA output cables from your turntable to the appropriate INPUTS on the TEC TC-760LC (MM or MC, depending on your cartridge type).
    • Connect the ground wire from your turntable to the Ground terminal on the preamplifier. Secure the connection by tightening the screw.
  3. Connect Preamplifier zu AmpSender/Empfänger:
    • Connect the RCA output cables from the TEC TC-760LC's OUTPUT jacks to a line-level input on your amplifier or receiver (e.g., AUX, CD, Tuner). Wichtig: Do NOT connect to your amplifier's dedicated PHONO input, as this unit is already a phono preamplifier and connecting to another phono input will result in distorted sound.
  4. Netzteil anschließen: Plug the small barrel connector of the included AC power adapter into the DC Power Input on the rear of the preamplifier. Then, plug the AC power adapter into a suitable wall outlet.
  5. Select Cartridge Type and Impedance: Use the MC/MM Select switch on the front panel to match your turntable's cartridge type. For Moving Coil cartridges, ensure the correct impedance (20Ω or 100Ω) is selected via the small switches located near the MC input jacks on the rear panel. Consult your MC cartridge's specifications for the recommended impedance.
  6. Einschalten: First, power on your amplifier/receiver, then power on the TEC TC-760LC.

6. Bedienungsanleitung

Sobald die VorampDer Verstärker ist eingerichtet. Befolgen Sie für den Betrieb diese Schritte:

  1. Eingabe auswählen: Double-check that the MC/MM switch on the front panel is set to match your turntable's cartridge type (MM or MC).
  2. Pegel anpassen: Start with the Level Control knob on the front panel at its minimum (lowest volume) setting.
  3. Aufnahme abspielen: Place a record on your turntable and begin playback.
  4. Lautstärke anpassen: Slowly increase the Level Control on the TEC TC-760LC and the main volume on your amplifier/receiver to achieve the desired listening level. Avoid setting the Level Control too high, which can lead to distortion.
  5. Monitorton: Listen carefully for any unwanted hum, buzzing, or distortion. If present, refer to the Troubleshooting section.

7. Wartung

To ensure the longevity and optimal performance of your phono preampVerstärker, befolgen Sie diese Wartungsrichtlinien:

  • Reinigung: Clean the unit with a soft, dry, lint-free cloth. Do not use liquid cleaners, abrasive pads, or chemical solvents, as these can damage the finish or internal components.
  • Staubkontrolle: Keep the unit free from dust and debris. You may use a soft brush or compressed air to gently remove dust from vents and connectors.
  • Belüftung: Ensure proper ventilation around the unit. Do not block any ventilation openings, and avoid placing the unit in enclosed spaces that could lead to overheating.
  • Verbindungen: Periodically check all cable connections to ensure they are secure and free from corrosion. Loose connections can lead to signal loss or noise.
  • Lagerung: Wenn Sie das Gerät über einen längeren Zeitraum lagern, trennen Sie es vom Stromnetz und bewahren Sie es an einem kühlen, trockenen Ort auf, idealerweise in der Originalverpackung.

8. Fehlerbehebung

If you encounter issues with your TEC TC-760LC, consult the table below for common problems and their solutions:

Häufige Probleme und Lösungen
ProblemMögliche UrsacheLösung
Kein Ton oder sehr geringe Tonausgabe.
  • Falsche Kabelverbindungen.
  • Wrong MM/MC selection.
  • Low volume settings on preamplifier oder ampschwerer.
  • Faulty power adapter or no power.
  • Verify all RCA cables are securely connected to the correct inputs/outputs.
  • Ensure the MM/MC switch matches your cartridge type.
  • Increase the Level Control on the preamplifier and the volume on your amplifier/Empfänger.
  • Check if the power indicator LED is on. Ensure the power adapter is properly connected and plugged into a live outlet.
Summen oder Brummen.
  • Improper grounding of the turntable.
  • Interference from other electronic devices or power cables.
  • Loose or damaged cable connections.
  • Incorrect MC impedance setting.
  • Ensure the turntable's ground wire is securely connected to the preampErdungsanschluss des Verstärkers.
  • Verschieben Sie die Voreinstellungamplifier away from other electronic devices (e.g., power supplies, Wi-Fi routers) and route audio cables away from power cables.
  • Check all RCA connections for tightness and inspect cables for damage.
  • For MC cartridges, try switching between 20Ω and 100Ω impedance settings to find the quietest option.
Verzerrter Ton.
  • Overdriven input (Level Control too high).
  • Incorrect MM/MC selection.
  • Faulty turntable cartridge or stylus.
  • Reduce the Level Control on the preampschwerer.
  • Confirm the correct MM/MC setting for your cartridge.
  • Inspect your turntable cartridge and stylus for damage or wear. Replace if necessary.

9. Spezifikationen

  • Produktabmessungen: 7 x 3 x 1.5 Zoll (17.8 x 7.6 x 3.8 cm)
  • Artikelgewicht: 2 Pfund (0.91 kg)
  • Hersteller: Technolink
  • Modellnummer: TC-760LC BLACK
  • Gesamte harmonische Verzerrung: 0.005 %
  • RIAA Frequency Response: 20Hz-20,000Hz +/- 0.5dB
  • Signal-Rausch-Verhältnis (S/N): 82dB (MM) / 85dB (MC)
  • Gewinnen: 38dB (MM) / 58dB (MC)
  • MM Input Impedance: 47kΩ
  • MC Input Impedance: Selectable 100 ohm / 20 ohm
  • Stromversorgung: 12V DC, 1A (via included AC adapter)

10. Garantie und Support

This product is typically covered by a manufacturer's warranty. Please refer to the documentation included with your purchase for specific warranty terms and conditions, including the duration and coverage details. For technical support, troubleshooting assistance beyond this manual, or service inquiries, please contact your retailer or the manufacturer, Technolink. Keep your proof of purchase for warranty claims.

© 2024 TEC. All rights reserved. Information in this manual is subject to change without notice.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.