TS710 – V2 Single Channel Timer
Installation Guide
TS710 – V2 Single Channel Timer
FP720 – V2 Two Channel Programmer
Installation Guide
1. Installation Steps
User Guide can be downloaded from: heating.danfoss.com.
- Installation must be done by an authorized electrician.
- Remove and mount timer/programmer back plate
direct to wall or on wall box, and wire as required for
application, see fig. 1 & 2 on page 16. The backplate
included within the product packaging should be
used for the installation. - Remove battery backup tab, see fig. 3 on page 17.
- Locate hooks at top of timer/programmer into top of
back plate, lower into position and tighten retaining
screws.
2. Dimensions and Wiring
See fig. 4 for dimensions and fig. 5 for wiring diagram
on page 18 and page 19.
3. Technical Specifications
|
Speci cations |
TS710 – V2 |
FP720 – V2 |
|
Operation |
Continuous use |
|
|
Operating voltage |
230 Vac ± 10 % 50/60 Hz |
|
|
Output |
Volt free |
2 x 230 Vac |
|
Switch rating |
3A (1) at 230 Vac |
|
|
Switch type |
1x SPDT Type 1B |
2x SPDT Type 1B internally linked |
|
Terminals |
max 2.5 mm2 wires |
|
|
IP rating |
IP30 (installed) |
|
|
Construction |
EN60730-2-7 |
|
|
Control pollution situation |
Degree 2 |
|
|
Rated impulse voltage |
4 kV |
|
|
Software classi cation |
A |
|
|
Storage conditions |
Relative Humidity 5 – 95% Ambient (storage and shipping) -10 to 60°C |
|
This product is an electronic heating timer/programmer for control of domestic central heating and domestic hot water.
Danfoss Ltd.
22 Wycombe End, HP9 1NB,
Danfoss A/S
Climate Solutions • danfoss.com • +45 7488 2222
Any information, including, but not limited to information on selection of product,
its application or use, product design, weight, dimensions, capacity or any other
technical data in product manuals, catalogues descriptions, advertisements, etc. and
whether made available in writing, orally, electronically, online or via download, shall
be considered informative, and is only binding if and to the extent, explicit reference is
made in a quotation or order confirmation. Danfoss cannot accept any responsibility
for possible errors in catalogues, brochures, videos and other material. Danfoss reserves
the right to alter its products without notice. This also applies to products ordered but
not delivered provided that such alterations can be made without changes to form, t
or function of the product. All trademarks in this material are property of Danfoss A/S
or Danfoss group companies. Danfoss and the Danfoss logo are trademarks of Danfoss
A/S. All rights reserved.
Documents / Resources
 |
Danfoss TS710 - V2 Single Channel Timer [pdf] Installation Guide TS710, FP720, TS710 - V2 Single Channel Timer, TS710 - V2, Single Channel Timer, Channel Timer |
