Danfoss MI.33.D2.02 VLT Profibus Adapter
Product Information
- Product Name: D-Sub9 Profibus Kit
- Connector Type: D-sub 9 Pin
- Compatibility: Profibus
- Trademark: VLT (registered Danfoss trademark)
Product Usage Instructions
Installation:
- Before installing the D-Sub9 Profibus Kit, make sure to remove the rubber band.
- Connect the pins of the D-sub 9 connector as per the following configuration:
Pin Signal 1 Not connected 2 Not connected 3 Rx/Tx + 4 CS 5 GND 6 5 V bus 7 Not connected 8 Rx/Tx – 9 Not connected
FAQ
- Q: What should I do if I encounter connection issues after installing the D-Sub9 Profibus Kit?
- A: If you experience connection problems, double-check the pin connections and ensure the rubber band has been removed before installation.
- Q: Is the D-Sub9 Profibus Kit compatible with all Profibus devices?
- A: The D-Sub9 Profibus Kit is designed for Profibus applications, but compatibility may vary depending on the specific devices used. It is recommended to check the compatibility with your device’s specifications.
Kit Instruction
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter Its products without notice. This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss IVS. All rights reserved.
Documents / Resources
 | Danfoss MI.33.D2.02 VLT Profibus Adapter [pdf] Instruction Manual MI.33.D2.02 VLT Profibus Adapter, MI.33.D2.02, VLT Profibus Adapter, Profibus Adapter, Adapter |
