Danfoss - logoENGINEERING
TOMORROW
Installation guide

A2L Gas Sensors

Relay, MODBus and Dual Output

Danfoss A2L Gas Refrigerant Detection Sensors - iconElectrical connection:See product labelAmbient temperature
Standard 6 pin
Danfoss A2L Gas Refrigerant Detection Sensors - icon1
Danfoss A2L Gas Refrigerant Detection Sensors - icon2Mounting holes are sized #10 or
#12 self-tapping sheet metal
screws.
To prevent water pooling, position the
sensor with the logo facing up.
Flat surface, for better performance.
Danfoss A2L Gas Refrigerant Detection Sensors - icon3
Recommended tightening torque is 3N-m.
LED will indicate the sensor status when it is powered up.
The LED is located on the reverse side of the sensor, near the membrane.
Danfoss A2L Gas Refrigerant Detection Sensors - icon4Solid green light: Sensor power-up on and
self-test Blinking green: Normal operation
(heartbeat).
Solid red: Alarm state – gas detected.
Blinking red: Sensor fault
Danfoss A2L Gas Refrigerant Detection Sensors - icon5

When mounted, the led will be
visible by reflection on the
mounting surface.

Make sure that the connecting
wire is not overstretched.
Connector should not be directing
upwards, in order to ensure IP
enclosure.
Preferred mounting positions
Danfoss A2L Gas Refrigerant Detection Sensors - icon6
Danfoss A2L Gas Refrigerant Detection Sensors - icon7UL 60335-2-40 ed. 4

Any information, including, but not limited to information on selection of product, its application or use, product design, weight, dimensions, capacity or any other technical data in product manuals, catalogues descriptions, advertisements, etc. and whether made available in writing, orally, electronically, online or via download, shall be considered informative, and is only binding if and to the extent, explicit reference is made in a quotation or order confirmation. Danfoss cannot accept any responsibility for possible errors in catalogues, brochures, videos and other material. Danfoss reserves the right to alter its products without notice. This also applies to products ordered but not delivered provided that such alterations can be made without changes to form, fit or function of the product.
All trademarks in this material are property of Danfoss A/S or Danfoss group companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/S. All rights reserved.

© Danfoss | Climate Solutions | 2023.08
AN461646924518en-000101Danfoss - logo

Documents / Resources

Danfoss A2L Gas Refrigerant Detection Sensors [pdf] Installation Guide
A2L Gas Refrigerant Detection Sensors, A2L, Gas Refrigerant Detection Sensors, Refrigerant Detection Sensors, Detection Sensors

References

Leave a comment

Your email address will not be published. Required fields are marked *