OliveTech Plug In Diffuser User Manual
Product Structure
The OliveTech Plug-In Diffuser consists of the following parts:
- Switch: Controls the operation of the diffuser.
- Cover: The top part of the diffuser.
- Essential Oil Bottle: Holds the essential oil.
- AC Plug: Connects the diffuser to the power outlet.
Diagrams illustrating the product structure are not included in this text-based format.
Operation Guide
Follow these steps to operate the diffuser:
- In the shutdown state, remove the top cover. [Fig1]
- Rotate clockwise to remove the essential oil bottle connected to the top cover. [Fig2]
- Add essential oils to the bottle, then twist the bottle counterclockwise and tighten it onto the top cover. (Do not overtighten to avoid damaging the sealing ring).
- Install the top cover onto the machine body while it is turned off. [Fig3]
- Operating the machine: [Fig4]
- Plug the two pin plugs on the back of the machine into the power socket.
- Locate the switch on the left side of the machine. It has three settings: "OFF" (center), "HIGH", and "LOW".
- "HIGH" setting: Runs for 30 seconds and stops for 2 minutes. This cycle repeats for 12 hours before automatically closing and resuming after 12 hours.
- "LOW" setting: Runs for 30 seconds and stops for 4 minutes. This cycle repeats for 12 hours, then automatically closes and resumes after 12 hours.
- Recommendation: Set on the low setting; 10ml of essential oil will last 9-10 days.
Cautions
- This scent diffuser is designed for fragrance oils without adding water.
- Keep the diffuser out of reach of pets and children for safety.
- Do not use the machine upside down, as it may cause leakage.
- Do not place the diffuser in high temperature or humid environments.
- Do not spill water or corrosive liquid on or inside the machine.
- Do not modify, disassemble, or repair the machine without authorization. Contact customer service or technical support for assistance in case of failure.
- Do not fill the bottle with corrosive or high-viscosity liquid.
- Do not mix different essential oils.
- Before changing the essential oil, wash the essential oil bottle and fill it with purified water. Run the machine on "high" for a period to clean the internal piping.
- When the machine is not in use for a long time, keep it clean and dry. Ensure it is clean before use.
Specifications
| Specification | Details |
|---|---|
| Dimensions | 3.1x2.6x5 inches |
| Power Input | AC100-240V 50/60Hz |
| Power | 5W |
| Materials | PP |
| Essential oil bottle capacity | 10ml |
Attention
- The strength of the scent depends on the purity and concentration of the essential oils used.
- Longer spraying and shorter pause times result in a stronger fragrance.
Troubleshooting
Refer to the guide below to diagnose and resolve issues before requesting repair service.
| Issue | Solution |
|---|---|
| No power | Check that the power cord is firmly plugged into the outlet. |
| No diffusion | Check mode settings, timer cycle, and reconnect or replace the air pump. |
| Weak diffusion | Clean or replace atomizer; check gasket and tube connection. |
| Abnormal noise | Retighten or replace the air pump. |
| No airflow/spray | Reinstall oil bottle; press and test nozzle, clean if blocked. |
Accessory
- 2x 10ml Essential Oil
- 1x User Manual
Customer Support
OliveTech strives to provide the best customer service. For any questions, please contact OliveTech customer service or technical support.
Email: olivetech-service@hotmail.com
Alternatively, contact OliveTech directly via Amazon.com. Navigate to "Your Orders", find the order for this product, click "Contact seller", select "Other", and send an email.