Jaz logoJaz Wireless Stereo Earphones

Jaz Wireless Stereo Earphones


  • Di-wifr: V 5.0
  • Sensitifrwydd: 98dB
  • Ystod Gweithio: 10m
  • Pwer siaradwr: 20mW
  • Amledd radio: 2.4GHz
  • Rhwystriant: 32Ω
  • Amlder: 20Hz - 20kHz
  • Ystumio: ≤ 2%
  • Earbuds batri: 35mAh
  • Achos codi tâl: 400mAh
  • Amser wrth gefn: 100hours
  • Amser codi tâl: 1.5hours
  • Amser gweithio: oriau 4


Jaz Wireless Stereo Earphones 1

Codi tâl ar y earbuds
Insert the earbuds into the charging case, the LEDs will light up. Once charging is complete, the LEDs will turn off.
Codi tâl ar yr achos
Insert the Type C connector of the supplied cable into the Type C port on the case and the other end into a USB port. The LED on the case will start flashing during charging.
Powering on earbuds
Remove the earbuds from the charging case: they will automatically turn on and pair with each other, or press both MLF buttons on the earbuds for 5 seconds.
Diffodd y earbuds
Insert the earbuds into the charging case: they will turn off automatically,
When the earbuds are not paired with a device and are out of the charging case, they will automatically turn off after 2 minutes, Or press the MLF button on one of the earphones for 5 seconds.

Pâr gyda dyfais

  1. Take the earbuds out of the charging case: they will automatically turn on and pair with each other.
  2. Turn on Bluetooth on the device and search for “ JAZ TWS CHANE’ “ in the list of available devices, then select it.
  3. After the first pairing with the device (if Bluetooth is turned on) the earbuds will automatically pair each time they are removed from the case.


Gorchymyn Gweithred Botwm
Chwarae / oedi cerddoriaeth 1 tap Chwith / dde
Cynorthwyydd llais Cynnal Chwith / dde
Trac blaenorol 3 tap Chwith
Trac nesaf 3 tap Hawl
Ateb galwad 1 tap Chwith / dde
Diwedd yr alwad 1 tap Chwith / dde
Gwrthod galwad sy'n dod i mewn Cynnal Chwith / dde
Dwyn i gof y rhif diwethaf 2 tap Chwith / dde

If the two earbuds do not pair with each other and both LEDs are flashing, they need to be reset: press the MLF button on the earbuds twice in succession and place them back in the charging case.Remove the earbuds and wait until they are recognised and paired correctly.

Dogfennau / Adnoddau

Jaz Wireless Stereo Earphones [pdf] Llawlyfr Defnyddiwr
Wireless Stereo Earphones, Earphones

Gadael sylw

Ni fydd eich cyfeiriad e-bost yn cael ei gyhoeddi.