JBL CSSG20 ON Camera Logo

JBL CSSG20 AR Feicroffon Dryll Camera

JBL CSSG20 AR Ganllaw Defnyddiwr Meicroffon Drylliau Camera

Diolch am ddewis Meicroffon Dryll Ar-Gamera JBL Commercial CSSG20. Bydd y canllaw hwn yn eich helpu i sefydlu a gweithredu'ch meicroffon. Gellir cysylltu CSSG20 â'r ddau gamerâu a ffonau clyfar (gan ddefnyddio'r cebl hollti). Mae'n berffaith wrth greu fideos casglu newyddion, vlogging, fideos youtube, interviews & llawer mwy.

CYNNWYS BLWCH

  1. CSSG20 on-camera shotgun mic with attached cable with 3.5mm connector
  2. Sgrin wynt
  3. 3.5mm splitter cable

CANLLAWIAU RHANNAU A SWYDDOGAETHAU

JBL CSSG20 ON Camera Shotgun Microphone User Fig1

  1. Power switch – slide to turn ON & OFF the device.
  2. Power LED – glows GREEN when the battery has sufficient power, glows RED when the battery is low.
  3. Gain setting – adjust the gain of the microphone according to the connected device & recording situation. At +10dB the microphone is most sensitive & at -10dB it is least sensitive.
  4. High pass filter – slide to “ “ position to turn ON the filter.
  5. Battery compartment – insert 1.5V AA battery as shown.
  6. Cable with 3.5mm TRS connector to connect with DSLR/Camera.JBL CSSG20 ON Camera Shotgun Microphone User Fig2
  7. Cold shoe – to attach the microphone to DSLR/Camera/suitable stands.
  8. Knob – tighten this to lock the microphone to the cold shoe mount.
  9. ¼” socket – use this to mount the microphone on a suitable mounting stand.
  10. Windscreen – used to prevent wind & pop noise.

MEWNOSOD BATERY

  • Open the battery compartment & insert the battery as shown. Make sure the +/- polarity of the battery is correct & close the compartment.JBL CSSG20 ON Camera Shotgun Microphone User Fig3

CONNECTING WITH DSLR/CAMERAS

  • Connect the microphone 3.5mm connector with DSLR/camera. Turn ON the microphone. Adjust the gain & high pass filter according to the recording situation. You may use the output from the camera to monitor the recording.JBL CSSG20 ON Camera Shotgun Microphone User Fig4

CONNECTING WITH SMARTPHONES/TABLETS

  • Use the splitter cable provided in the box to connect the microphone with the smartphone/tablet. Plug the splitter cable in the smartphone & connect the microphone into the jack marked as , plug a headphone into the jack marked to monitor the playback from a smartphone.JBL CSSG20 ON Camera Shotgun Microphone User Fig5

NODWEDDION

  • High sensitivity condenser capsule with the super-cardioid pickup pattern
  • Adjustable microphone gain in three steps, – 10dB, 0dB & +10dB
  • Built-in high pass filter to cut noise below 200Hz
  • Standard cold shoe mount for convenient installation on camera
  • An integrated shock mount to reduce mechanical & vibrational noise
  • Powered by a single 1.5V AA battery giving more than 80 hours of operation time
  • Dangosydd batri isel

MANYLEBAU

Patrwm pegynol Super-cardioid
Transducer Capsiwl cyddwysydd 10mm
ymateb amledd 50Hz - 16KHz
Sensitifrwydd -25dB ± 3dB

(0dB = 1V / Pa yn 1KHz)

Ennill addasiad -10dB/ 0dB/ +10dB
Hidlydd pasio uchel 200Hz 12dB/Oct
rhwystriant allbwn 2.2KΩ ± 30%
Cyflenwad pwer 1.5V AA battery (approx. 80 hours)
Dimensiynau allanol L 157mm x H 48mm
Tube dimensions Dia. 11mm x L120mm
Pwysau net 75g (tua)

YMATEB AMRYWIAETH

JBL CSSG20 ON Camera Shotgun Microphone User Fig6

PATRWM POLAR

JBL CSSG20 ON Camera Shotgun Microphone User Fig7

Dogfennau / Adnoddau

JBL CSSG20 AR Feicroffon Dryll Camera [pdf] Canllaw Defnyddiwr
CSSG20, AR Feicroffon Dryll Camera

Gadael sylw

Ni fydd eich cyfeiriad e-bost yn cael ei gyhoeddi.