CRLACON RF Controller
“
Product Information
Specifications:
- Compliance: Part 15 of FCC Rules
- Class: B digital device
- RF Radiation Exposure Limits: Must maintain a separation
distance of at least 20 cm from all persons
Product Usage Instructions
Important Notes:
- Do not power on the device before completing installation.
- You can control the devices using the designated App.
Installation Guidelines:
- Ensure the device is placed in a suitable location as per the
installation instructions. - Follow the provided guidelines for connecting any necessary
cables or components. - Only power on the device after completing all installation
steps.
Operation Instructions:
- Download and install the designated App on your smartphone or
tablet. - Follow the App’s setup instructions to connect and configure
your devices. - You can now control and manage your devices remotely via the
App.
FAQ (Frequently Asked Questions)
Q: Can I power on the device before installation is
completed?
A: No, it is important to complete the installation before
powering on the device to avoid any issues.
Q: How do I control the devices?
A: You can control the devices using the designated App provided
with the product. Simply download and follow the setup
instructions.
“`
User Manual
NOTE:
1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation.
2.Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
3.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
·Reorient or relocate the receiving antenna. ·Increase the separation between the equipment and receiver. ·Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ·Consult the dealer or an experienced radio/TV technician for help.
4.This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1) L’appareil ne doit pas produire de brouillage; 2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
The following RF exposure warning is only for RF CONTROLLER
This equipment complies with FCC’s and IC’s RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this transmitter must be installed and operated to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. Installers must ensure that 20cm separation distance will be maintained between the device and users.
Cet appareil est conforme aux limites d’exposition au rayonnement RF stipulées par la FCC et l’IC pour une utilisation dans un environnement non contrôlé. Les antennes utilisées pour cet émetteur doivent être installées et doivent fonctionner à au moins 20 cm de distance des utilisateurs et ne doivent pas être placées près d’autres antennes ou émetteurs ou fonctionner avec ceux ci. Les installateurs doivent s’assurer qu’une distance de 20 cm sépare l’appareil des utilisateurs.
Warning:
Do not power on the device before completed installation.
You can control the devices by App now.
Documents / Resources
 |
Crystal Rail CRLACON RF Controller [pdf] User Guide 2AB4J-CRLACON, 2AB4JCRLACON, CRLACON RF Controller, CRLACON, RF Controller, Controller |
