CREATE RC60 Antenna Rotators System

CREATE RC60 Antenna Rotators System

Introduction

The RC series rotator system is designed for heavy duty applications where medium to high rotating/braking torques are required and also high vertical loads are imposed as well. Provided with two points trunnion mounting fixture, this rotator may be easily adapted to the most applications. The output shaft is 8 bolts flange mount casting. The rotator drive shaft will concentrically accommodate coaxial transmission lines up to 5.5 to 14 cm diameter with provisions for rotatory joints at the base which are available as an optional accessory. This system is supplied complete with rotator pedestal and azimuth indicator/control unit. Model RCxx-M is also available other than the RCxx series. The RCxx-M is able to remotely control the rotator through the radio communication equipments or through the telephone line.

SPECIFICATIONS

ModelRC20RC70RCIO0RCIO0B
Rotating Torque50 kg·m100 kg·m300 kg·m300g·m
Braking Torque400 kg·m500 kg·m800 kg·m1000 kg·m
Maximum Vertical Load1500 kg5000 kg7000 kg8000 kg
Rotation Speed (50 Hz)1 RPM0.8 RPM0.8 RPM0.8 RPM
Forward-Reverse Delay3 sec.3 sec.5 sec.5 sec.
Power Requirements,
Single PH. 50—60Hz.115,220,240 VAC. ±15V230 VAC. ±15V
Drive TypeGear & Chain
Total Reduction1430:11800:11800:11800:1
Control Accuracy±5 degree±5 degree±5 degree±5 degree
Operating Temperature– 30 ° C ~ +50 ° C.
Inside Diameter/Rotary Shaft56mm90 mm135 mm135 mm
Control Cable8-core8-core8-core8-core
Weight, Net/Rotator70 kg170 kg240 kg290 kg

Electrical and mechanical specifications for the model RCxx-M are the same as above.

DIMENSIONS ARE MILLIMETERS

Dimension

Creative Design Corp.
4-8 Asano-cho Kawasaki-ku Kawasaki 210-0854 Japan
Tel: (81 )-44-333-668 I/Fax: (81 )-44-333-6598

Logo

Documents / Resources

CREATE RC60 Antenna Rotators System [pdf] Instructions
RC60 Antenna Rotators System, RC60, Antenna Rotators System, Rotators System

References

Leave a comment

Your email address will not be published. Required fields are marked *