COOPERLIGHTING L65X Series Track 
System Instructions

COOPERLIGHTING L65X Series Track System Instructions

INSTALLATION INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS

  1. Read all of these installation instructions before installing the track system.
  2. Save These Instructions and refer to them when additions or changes in the track configuration are made.
  3. Disconnect electrical power before adding to or changing the configuration of the track.
  4. For use with L65X Series track systems only.
  5. Electrical ratings: 120V, 60Hz, 20A

COOPERLIGHTING L65X Series Track System Instructions - INSTALLATION INSTRUCTIONS

Installation Instructions For LZR203 Adjustable “L” and Straight Feed Connector
NOTE: For use with L65X series Track systems only.
NOTE: Ground contact must be on the same side as the Polarity Groove of the track. If Polarity Groove and Ground Contact does not line up remove 2-screws from cover, remove cover and adjust connector 180º. Install cover and screws. (If used as a Power Feed DO NOT INSTALL COVER until wire con-nections are made as noted below). Electrical ratings: 120v, 60HZ, 20A.

Step1. Insert ends of connector into ends of track (Polarity arrow must line up with Polarity Groove of track.) Secure to track by hand-tightening lock screws at the tip of connector until snug. DO NOT OVER TIGHTEN. This may distort track.

IF USED AS A POWER FEED POINT

Step1. Insert ends of connector into ends of track (Ground Contact must line up with Polarity Groove of track.) Secure to track by hand-tightening lock screws at the tip of connector until snug. DO NOT OVER TIGHTEN. This may distort track.
Step2. Remove knock-out from back plate. Attach supply fitting (supplied by others) by installing through back plate and securing with speed nut (supplied by others).
Step3. Strip supply wires to proper length using gauge on inside of connector (1/2″ nominal strip length). Pull supply wires into connector. Connect power supply wire (colored) LINE terminal and neutral wire (white) to NEUT terminal. If a ground wire is available it should be connected to the screw marked GND. As shown in FIG C. Wires must be routed as shown to assure proper closure of connector cover.

COOPERLIGHTING L65X Series Track System Instructions - Fig A,B,C

COOPER Logo

Cooper Lighting Solutions 1121 Highway 74 South Peachtree City, GA 30269 P: 770-486-4800 www.cooperlighting.com
© 2024 Cooper Lighting Solutions All Rights Reserved Printed in China Imprimé en Chine Impreso en China

Documents / Resources

COOPERLIGHTING L65X Series Track System [pdf] Instructions
L65X Series, LZR203, L65X Series Track System, L65X Series, Track System, System

References

Leave a comment

Your email address will not be published. Required fields are marked *