PIM Guard SnapTak Hanger: SSH-2630
for 26-30mm cables
SSH-2630 PIM Guard SnapTak Hanger
Squeeze gripping tabs and insert SnapTak adjustable cable hanger into 3/4 inch hole. Polymer SnapTak hangers may be snapped into any other CommScope Snap-in hangers or adapters. 
Typical acceptable stack combinations.
Squeeze gripping tabs to remove SnapTak adjustable cable hanger.
WARNING
Be careful not to damage latches when the hanger is installed and removed from the hole.
| Part Information for Available Hangers | ||
| Part Number | Stackability | Cable Diameter Range mm(in) |
| SSH-2630 | 3 | 26.00(1.02) min to 30.00(1.18) max |
Notice: CommScope disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
CommScope
1100 CommScope Place SE P.O. Box 339, Hickory, NC 28603-0339
828-324-2200 800-982-1708
www.commscope.com
Customer Service 24 hours
Technical Support :+1 888 297 6433,
Option 3 (Toll Free US and Canada): +1 828 323 4220,
Option 3 (local): https://www.commscope.com/wisupport(open a ticket)
Documents / Resources
 | COMMSCOPE SSH-2630 PIM Guard SnapTak Hanger [pdf] Installation Guide SSH-2630, SSH-2630 PIM Guard SnapTak Hanger, PIM Guard SnapTak Hanger, Guard SnapTak Hanger, SnapTak Hanger, Hanger |