LMMF Plug 2 Simplified Wiring

LMMF Plug 2 Simplified Wiring

Symbol LMMF Simplified Wiring – Harness Install Guide

Symbol CONNECT THE ECM

  • Use the 2x 7mm bolts to mount your ECM.
  • The ECM connectors are color-coded: Blue and Clear — match them accordingly.

Symbol COIL PACK POWER

  • Locate the loom with 2 plugs.
  • Plug 1: Install the Coil Power plug on the side closest to the alternator.
  • Plug 2: Install the second plug on the opposite side of the coil pack, next to the crank sensor.
  • Note: The crank sensor wire runs from the coil pack to the back of the engine block.
    Coil Pack Power

Symbol SENSOR CONNECTIONS (3-PLUG LOOM)

You’ll find a loom with:

  • 1x Gray plug
  • 1x 4-pin Black plug
  • 1x 3-pin plug

Plug them in as follows:

  • Throttle Position Sensor (TPS) – Sometimes hard to see
  • Idle Air Control (IAC) – Plug this in directly
  • Intake Air Temp (IAT)
    Sensor Connections (3-Plug Loom)

Symbol ALTERNATOR & INJECTOR HARNESS

Locate the final loom which includes:

  • Alternator plug
  • Injector harness plugs

Symbol Your engine should have plugs that match.

Symbol Note: If your engine is from 1989–1995, you will need a injector harness (we make them new) Also:

  • Plug in the 5-pin connector
  • Plug in the 10-pin connector
  • Plug in the alternator

OR if it’s a 2000-2005 it will only have 1 16 pin plug in place of the 5-pin connector and the 10 pin connector.

Alternator & Injector Harness

Symbol MAIN POWER WIRING

  • Run a wire from the large post on the alternator to your battery positive.
  • Run a heavy gauge wire from:
    • Starter power → Battery
    • Crank wire → Push button starter

Symbol BATTERY & TOGGLE WIRING

  • Locate the grey-coated wire pack with a red and black — these go directly to the battery.
  • A single red wire should be connected to your toggle switch or other “ignition” kill method.
  • New harnesses only have 1 power and 1 ground to avoid confusion. If you want it to have memory power call me and I can walk you through setting that up.

Symbol TRANSMISSION HOTWIRE

You’ll need to hotwire your transmission.
Need help? I sell a hotwire kit that works for:

  • 4T60E
  • 4T65E
  • 4T65HD

Logo

Documents / Resources

LMMF Plug 2 Simplified Wiring [pdf] Instructions
Plug 2, Plug 1 Coil Power, 3-Plug Loom, Alternator Injector Harness, Transmission Hotwire, Plug 2 Simplified Wiring, Simplified Wiring, Wiring

References

Leave a comment

Your email address will not be published. Required fields are marked *