Clinton Electronics CE-PS102 Power Over Ethernet Installation Guide

 CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT DISASSEMBLE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICE TO QUALIFIED PERSONNEL.

WARNING:

• To reduce the risk of fire or electric shock, do not expose the unit to rain or moisture. Do not install power supplies in places with high moisture or near water.
• This installation should be made by qualified service personnel and should conform to all local codes and in accordance with the National Electrical Code.
• For Indoor Use Only!
• Risk of electrical shock and/or equipment damage. Disconnect power before servicing this appliance.
• Measure output voltage before connecting devices. This helps avoid potential damage.

Wall Mount – Optional
Measure approximate 3-15/16″ (100mm) and make two marks. Insert appropriate screws into desired mounting surface, leaving enough of the heads of the screws exposed to hang the PoE Injector on. Guide the PoE Injector onto the two screws and hang in place.

Interlocking Slide Mount – Optional
If desired, multiple PoE Injectors can be attached together. To attach, align the raised rail to from one PoE Injector to the slotted side on a second PoE Injector. Slide together until they snap in place.

INSTALLATION:

1. Connect CATSe/CAT6 cable from switch/hub to connector on CE-PS102 marked Data IN.
2. Connect CAT5e/CAT6 cable from IP camera or other network device to connector on CE-PS102 marked PoE OUT.
3. Connect AC power cord from PoE Injector to main power source.
   • During boot-up the LEDs should illuminate GREEN if proper power and PoE connections have been made. If LED indicators are not illuminated check cable connections.

Pin Assignment

1. Power – (negative)
2. Power – (negative)
3. Power+ (positive)
4. Data
5. Data
6. Power +(positive)
7. Data
8. Data

clintonelectronics I 6701 Clinton Road Loves Park, IL 61111 I 800.549.6393 (Support) I www.clintonolectronics.com

Documents / Resources

Clinton Electronics CE-PS102 Power Over Ethernet [pdf] Installation Guide CE-PS102 Power Over Ethernet, CE-PS102, Power Over Ethernet, Over Ethernet, Ethernet

References

• User Manual