Clarion CMR-20 Marine Wired Remote with LCD Display
WHAT’S IN THE BOX
INSTALLATION
GENERAL CONTROLS
![]() |
|
![]() SOURCE |
|
![]() SETTINGS |
|
BACK/MENU |
|
![]() FAVORITES |
|
![]() |
|
|
Short press to:
|
![]() |
Short press to:
|
Note: Control functionality will vary by the connected host source unit. |
INSTALLATION CONSIDERATIONS
- Installation requires appropriate tools and safety equipment.
- Professional installation is recommended.
- This product is water-resistant. Do not submerge or be subject to high-pressure water spray.
- Do not mount in areas of extreme heat.
- Mount this product securely to prevent damage or injury in severe conditions.
- Before cutting or drilling, check for potential obstacles behind mounting surfaces.
- Carefully route all system wiring away from moving parts and sharp edges.
- Secure all wiring and use grommets and loom where appropriate to protect from sharp edges.
IP67 WATER RESISTANCE RATING
This product has been tested to withstand immersion in water, up to 1 meter (3.28 ft.) deep, for up to 30 minutes (when properly installed). While designed to be water resistant, this product should never be submerged under water for prolonged periods or subjected to activity that creates pressure on it that exceeds its depth rating.
CONNECTION CAPACITY
Connect up to three wired remotes to a single source unit, at up to 75 ft (23m) away (cumulative cable length). Each wired remote connects directly using accessory controller cables and 2-way splitters (sold separately). Refer to the connected host source unit’s user manual for specific control functionality.
CMR20-MAN 032522
2022 Clarion Marine Audio
Documents / Resources
![]() |
Clarion CMR-20 Marine Wired Remote with LCD Display [pdf] Owner's Manual CMR-20 Marine Wired Remote with LCD Display, CMR-20, Marine Wired Remote with LCD Display, Marine Wired Remote, LCD Display Wired Remote, Marine Remote, Remote |