Categories: Cisco

CISCO Headset 720 Series Wireless USB A Adapter Instructions

Cisco Headset Wireless USB-A Adapter

Safety and Performance Information

Regulatory Domains

The radio frequency (RF) for this phone is configured for a specific regulatory domain. If you use this phone outside of the specific regulatory domain, the phone will not function properly, and you might violate local regulations.

External Devices

We recommend that you use good-quality external devices that are shielded against unwanted radio frequency (RF) and audio frequency (AF) signals. External devices include headsets, cables, and connectors.
Depending on the quality of these devices and their proximity to other devices, such as mobile phones or two-way radios, some audio noise may still occur. In these cases, we recommend that you take one or more of these actions:

  • Move the external device away from the source of the RF or AF signals.
  • Route the external device cables away from the source of the RF or AF signals.
  • Use shielded cables for the external device, or use cables with a better shield and connector.
  • Shorten the length of the external device cable.
  • Apply ferrites or other such devices on the cables for the external device.

REVIEW DRAFT – CISCO CONFIDENTIAL

  • Move the external device away from the source of the RF or AF signals.
  • Route the external device cables away from the source of the RF or AF signals.
  • Use shielded cables for the external device, or use cables with a better shield and connector.
  • Shorten the length of the external device cable.
  • Apply ferrites or other such devices on the cables for the external device.

Cisco cannot guarantee the performance of external devices, cables, and connectors.

Caution
In European Union countries, use only external speakers, microphones, and headsets that are fully compliant with the EMC Directive [89/336/EC].

UL Warning

The LAN/Ethernet cable or other cables attached to the device should not be extended outside of the building.

Product Label

The product label is located on the bottom of the device.

Compliance Statements

Compliance Statements for the European Union
CE Marking

The following CE mark is affixed to the equipment and packaging.

REVIEW DRAFT – CISCO CONFIDENTIAL


RF Exposure Statement for the European Union
This device has been evaluated and found compliant in accordance with EU EMF Directive 2014/53/EU.

Compliance Statements for the USA

FCC Compliance Statements
The Federal Communications Commission requires compliance statements for the following:
FCC Part 15.19 Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Part 15.21 Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement


This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must be at least 0.5 cm from the user and must not be collocated or operating in conjunction with any other antenna or transmitter.

Part 15 Radio Device

Caution
The Part 15 radio device operates on a non-interference basis with other devices operating at this frequency. Any changes or modifications to said product not expressly approved by Cisco, including the use of non-Cisco antennas could void the user’s authority to operate this device.

FCC Receivers and Class B Digital Statement
This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide easonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

REVIEW DRAFT – CISCO CONFIDENTIAL

If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna
  • Increase the separation between the equipment or devices
  • Connect the equipment to an outlet other than the receiver’s
  • Consult a dealer or an experienced radio/TV technician for assistance

Compliance Statements for Canada

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Privacy of communication may not be ensured when using this phone.
This product meets the applicable Innovation, Science, and Economic Development Canada technical specifications.

Canadian RF Exposure Statement

THIS DEVICE MEETS THE LIMITS AS REFERENCED BY ISED RSS-102 R5 FOR EXPOSURE TO RADIO WAVES
Your device includes a radio transmitter and receiver. It is designed not to exceed the General populace (uncontrolled) limits for exposure to radio waves (radio frequency electromagnetic fields) as referenced in RSS-102 which references Health Canada Safety Code 6 and includes a substantial safety margin designed to assure the safety of all persons, regardless of age and health. This equipment should be installed and operated with a minimum distance of 0.5 cm between the radiator & your body. The device has been tested and found compliant with the applicable regulations as part of the radio certification process.

Compliance Information for Japan

VCCI Compliance for Class B Equipment
“5.2/5.3GHz is limited to indoor use only in Japan”

Compliance Information for Brazil

Art. 6º – 506
This equipment is a secondary type device, that is, it is not protected against harmful interference, even if the interference is caused by a device of the same type, and it also cannot cause any interference to the primary type devices.
For more information, go to this URL: http://www.anatel.gov.br

Model Certificate Number
8811 3965-14-1086
8841 3965-14-1086
8845 4243-15-9863
8851 3965-14-1086
8851NR 3965-14-1086
8861 0463-15-1086
8865 06125-16-01086
8865NR 06125-16-01086

Compliance Statement for Singapore

Documents / Resources

CISCO Headset 720 Series Wireless USB A Adapter [pdf] Instructions
ADPT2497, LDKADPT2497, Headset 720 Series, Wireless USB A Adapter, Headset 720 Series Wireless USB A Adapter, USB A Adapter

References

Share

Recent Posts

QIYUE Mini Smartphone User Manual

Mini Smartphone 1.Q:SIM A: 2nano SIM1nano SIM 1 64GB SIM SD 2.Q: A:3 2 """…

2 seconds ago

beko CFB 9433 X , CFB 9433 XF Cooker Hood User Manual

CFB 9433 X , CFB 9433 XF Cooker Hood Cooker Hood User Manual CFB 9433…

4 seconds ago

CHE-640 Wireless Earbuds User Manual

CHE-640 Wireless Earbuds FCC Statement This equipment has been tested and found to comply with…

5 mins ago

BEAUTIFLY B-Glossy Blush Series Needleless Mesotherapy Device User Manual

B-Glossy Blush Series Needleless Mesotherapy Device

5 mins ago

SEALEY TP6801.V3 Heavy-Duty High Flow Lever Pump User Manual

TP6801.V3 Heavy-Duty High Flow Lever Pump HEAVY-DUTY HIGH FLOW LEVER PUMP MODEL NO: TP6801.V3 Thank…

5 mins ago

Bona Flexisand Service Kit Instruction Manual

Flexisand Service Kit EN DE FR ES SERVICE INSTRUCTIONS Bona Service Kit for Bona Flexisand…

6 mins ago