Cerwin Vega SM69F4 2-Way 6 X 9 4 Ohm Speaker With Flush Mount
Product Usage Instructions
Installation
- Ensure the mounting surface is clean and dry before installing the Pro Series Midrange driver.
- Use the provided mounting bezels to securely attach the driver in place.
- Avoid stripping the threaded horn bodies during installation.
Power Handling
- The driver has a maximum RMS power handling of 100W, ensure your audio system is compatible with this power output to prevent damage to the driver.
Crossover Setup
- Utilize the included 12dB crossover for maximum protection of the driver.
- Connect the crossover according to your audio setup requirements to optimize performance.
Maintenance
- If required, the driver’s diaphragm can be replaced using the re-buildable design with part number CVMPCL1.0STD.
- Follow instructions carefully for a successful replacement.
Filtering
- The driver has a Hi-Pass Filter set at 100 Hz with a 12dB Octave slope.
- Adjust your audio system settings accordingly to benefit from this feature.
FAQ
- Q: Can I use the Pro Series Midrange driver with any audio system?
- A: It is recommended to check the compatibility of the driver’s power handling and impedance with your audio system to ensure optimal performance and prevent damage.
- Q: How do I know if the diaphragm needs replacement?
- A: If you notice a decrease in audio quality or distortion, it might indicate a diaphragm issue. Refer to the user manual for guidance on replacing the diaphragm.
- Q: What is the purpose of the Bullet Phase Plug?
- A: The Bullet Phase Plug design enhances the driver’s response for improved audio quality and performance.
FEATURES
- The next generation of Cerwin Vega Pro Audio High Frequency driver’s features and specifications are on the next few pages.
- Make sure to read this manual and get to know your drivers and the many applications and set-up scenarios available to you.
- The PIT and P1SRT have threaded horn bodies and come with 3 mounting bezels that thread on. Be careful to not strip them.
P1T
- 1″ Pro Audio High Frequency drivers
- 50W/*100W MAX RMS Power Handling
- 107dB Sensitivity
- Composite Rubber Mounting Frame
- 12dB Crossover included for maximum protection
- Bullet Phase Plug for Better Response
- Re-buildable Diaphragm Replacement Design (part# CVMPCL1.0STD)
- Hi-Pass Filtered @ 100 Hz – 12dB Oct
SPECIFICATIONS
| Sensitivity | 107 dB 1W/1M |
| Frequency Response | 3K-20KHZ |
| Nominal Impedance | 4 ohm |
| Cut-out Diameter | 1.75″/44.45mm |
| Front of Horn to Magnet Depth | 1.3″/33.1mm |
| Depth Front to Back Magnet | 2.3″/58.7mm |
| Over-All Diameter | 2.28″/57.9mm |
| Over-All Depth | 2.7″/68.50mm |
Dimension
CONTACT
- CERWIN-VEGA YOUTUBE @CERWINVEGA_USA
- HELLO@CERWINVEGA.COM
- SUPPORT@CERWINVEGA.COM
- 213-261-4161
- ©2024 CERWIN VEGA. ALL RIGHTS RESERVED.
Documents / Resources
 | Cerwin Vega SM69F4 2-Way 6 X 9 4 Ohm Speaker With Flush Mount [pdf] Owner's Manual SM69F4, SM69F4 2-Way 6 X 9 4 Ohm Speaker With Flush Mount, 2-Way 6 X 9 4 Ohm Speaker With Flush Mount, 4 Ohm Speaker With Flush Mount, Speaker With Flush Mount, Flush Mount |