Raimondi Berta ADV
Chapter 3: Handling, installation, adjustments
Via dei Tipografi, 11-41122 Modena (Italia)Tel.: +39.059.280.888 - Fax: +39.059.282.808
www.raimondispa.com - e-mail: info@raimondispa.com
3.1 Packing transport
Before using the machine, check that there are no broken, worn or damaged parts; in such case proceed to a prompt substitution. For the substitution of parts and accessories, carefully follow the instructions contained in this manual.
[Image: A brown cardboard box with the 'RAIMONDI' logo on its side.]3.2 Electric supply
The "BERTAADV" electrosponge shall be supplied with the tension equal to the value indicated in the "TECHNICAL DATA" label; connect the machine only to a line featuring an efficient ground cable. In case of doubts, do not connect the machine. Connect the machine only to a 16A plug.
- MAXIMUM LENGTH 10 METERS (33');
- HAVING A SECTION SUITABLE FOR THE LOAD;
- BEING COMPLETELY UNCOILED.
The "BERTAADV" electrosponge must be connected to a power mains equipped with differential switch or insulation transformer of class II and matching the technical regulations of the destination country.
3.3 Machine assembly
Loosen the knobs (A), lift up the handle (B) and tilt it in the desired position, tighten the knobs (A).
