SOBO WP-1000F Aquarium Internal Filter Pump

Product Overview

The SOBO WP-1000F is an internal filter pump designed for aquarium water circulation. It features a filter sponge that absorbs dirt and clears the water, making it suitable for both freshwater and saltwater aquariums. The unit is fully submersible.

Key Features:

• Absorbs dirt and clears water
• Suitable for freshwater and saltwater
• Fully submersible

Specifications:

• Model: WP-1000F
• Power: 15W
• Flow Rate (F.MAX): 650 L/H
• Voltage: AC 220-240V
• Frequency: 50/60Hz

Safety Considerations

• Ensure the pump is operated within the specified voltage and frequency range.
• Do not use in flammable or corrosive liquids.
• The pump must be fully submerged during operation. Operating it out of water can cause permanent damage.
• Avoid operating the pump in water temperatures above 35°C or below freezing point.
• Do not use the pump if the power cord is damaged.
• When using the pump out of water (e.g., for water changes), ensure pipe fittings are secure and prime the pump with water, expelling any air.

Operating Considerations

• Always disconnect the pump from the electrical socket before performing any maintenance.
• Do not let the pump run dry or out of water for more than 5 minutes.
• Never lift or pull the pump by its power cord, as this can cause the cord to detach or become damaged.
• Turn off the pump and disconnect the power cord before removing it from the water.
• The maximum diving depth for this pump is 3 meters.
• If using an additional socket, ensure it matches the rated voltage and current of the power cord.

Maintenance

Regular maintenance will prolong the life of the pump.

• Remove the front cover and impeller cover, then the impeller unit.
• Use a small brush to clean the cylinder or wash away debris under running water.

Note on Installation: When plugging in the pump, ensure the power plug is inserted into the socket outlet at a higher point than the pump. This prevents water from flowing back through the wire to the socket outlet.

Performance

A clogged or dirty intake screen will reduce pump performance. Clean the intake screen regularly by removing surrounding debris. If a lower flow rate is desired, adjust the flow control lever.

Troubleshooting

If the pump fails to operate:

• Check that the pump unit is receiving a consistent power supply.

Quality Assurance

The product has passed inspection and meets the specified quality standards for factory release.

Inspection Date: 2022.12.12