Product Overview
This document provides instructions for the assembly, use, and disassembly of the Green Land G21 pop-up tent. It is available in 4x4 meter and 3x3 meter sizes.
Assembly Instructions
Follow these steps to assemble your Green Land G21 pop-up tent:
Step 1: Initial Setup
Place the tent in the center of the desired area. With two people, each person should grab two opposite legs of the tent. Lift the legs off the ground and take a step back to begin opening the frame.
[Diagram Description: Two people are shown holding opposite legs of a folded tent, lifting them slightly off the ground and stepping back to initiate unfolding.]
Step 2: Full Frame Extension
Hold the lower part of the frame on opposite sides. Lift the frame and move backward until the tent is fully open. Be careful not to pinch your fingers between the frame components.
[Diagram Description: A person is shown holding the lower frame and pulling it backward, causing the tent structure to extend fully.]
Step 3: Securing Corner Sliders
At each corner, push the sliding sections into place. Use one hand to push the slider and the other hand to hold the upper part of the leg. A locking pin should snap into the slot to secure it. Repeat this process for all four legs.
[Diagram Description: A close-up shows a hand pushing a sliding section on a tent leg into its locked position, with a visible locking pin engaging a slot.]
Step 4: Locking Inner Legs and Leveling
Lift two adjacent legs until the inner legs lock into place. Repeat for the other set of adjacent legs. The tent can be further adjusted or leveled using the adjustment holes located at the bottom of the legs.
[Diagram Description: Two adjacent legs are shown being lifted until their inner sections lock. The diagram also points to adjustment holes at the base of the legs.]
Important Information
- Wind: Use tent stakes or sandbags to secure the tent in windy conditions.
- Strong Wind: In very strong winds, it is recommended to disassemble the tent to prevent damage.
- Wet Fabric: If the tent fabric is wet, allow it to dry completely before folding it to prevent mold and mildew.
- Cleaning: Clean the tent using mild detergent and water.
- Rain: Do not leave the tent unattended during rain.
Disassembly Instructions
Follow these steps to safely disassemble your Green Land G21 pop-up tent:
Step 1: Releasing Leg Locks
Lift two legs slightly and press the release button on each. Slide the inner legs into the outer legs. Repeat this action on the opposite side of the tent.
[Diagram Description: A hand is shown pressing a release button on a tent leg, allowing the inner leg section to slide into the outer leg section.]
Step 2: Releasing Corner Sliders
At each corner, release the sliding part by pressing the release button. Repeat for all four corners.
[Diagram Description: A hand is shown pressing a release button on a corner slider mechanism of the tent leg.]
Step 3: Folding the Tent
Grab the top of the tent from opposite sides. Shake the tent slightly and move closer together until the tent is approximately 3/4 closed. Then, grab two legs and push them together to fold the tent completely. Be careful not to pinch your fingers.
[Diagram Description: Two people are shown holding the top of the tent, moving towards each other, then pushing the legs together to fold the tent completely.]
Contact Information
For inquiries or support, please contact:
SUOMITRADING.fi
Realparkinkatu 12
37570 Lempäälä
Tel: 010 430 3490
