Speed Brew Classic Coffee Makers
RISK OF FIRE OR ELECTRICAL SHOCK
TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK DO NOT DISASSEMBLE THE COFFEE MAKER NO USER-SERVICEABLE PARTS INSIDE REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY
Note: This symbol alerts you to important operating and service instructions.
Danger: This symbol alerts you to the risk of fire or electric shock in the accompanying message.
NOTE: The short power supply cord provided reduces the risk of becoming entangled in or tripping over a longer cord. If an extension cord is used, its marked electrical rating must be at least as great as the electrical rating of the coffee maker. Make sure the extension cord does not hang over the edge of a table or counter and that it cannot be pulled on by children or tripped over. The extension cord must be a 3-wire cord of the 3-pronged, 3-socketed, grounding type (including grounding conductor).
IMPORTANT: DO NOT PLUG IN UNTIL READING THE “INITIAL SETUP” SECTION.
PLEASE READ ALL INSTRUCTIONS BEFORE STARTING.
BREW CAPACITY: 4 to 10 (5) oz. cups per batch
ELECTRICAL: UL and C-UL Listed FOR HOUSEHOLD USE ONLY. The coffee maker has an attached, 3-prong grounded cord set and requires 2-wire service with the ground.
GRX: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
BX: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
SBS: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
CSB1: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
CSB2: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
BTX: 120 volts AC, 7 amps, single phase, 60 Hz, 850-watts
CSB3T: 120 volts AC, 7 amps, single phase, 60 Hz, 850-watts
Not designed for High Altitude locations above 4,000 feet. High Altitude units are available. See BUNN.COM for details.
Record the model and date code before using. The model and date code are located on the bottom of your coffee maker.
Register your product: www.bunn.com/home-support/resource-center/product-registration
Go to: https://retail.bunn.com/support/products or call customer service at 1-800-352-2866 (USA) or 1-800-263-2256 (Canada). Please have your model and date code ready when calling for service.
Follow basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock and personal injury.
DO NOT PLUG IN THE COFFEE MAKER UNTIL STEP 5, OR YOU RISK PERMANENTLY DAMAGING THE MACHINE.
Follow the steps on the next page for proper setup.
HAVE QUESTIONS? bunn.com/home-products/setup
NOTE: Your thermal carafe holds coffee hot for about 2 hours. For best results, preheat the carafe by filling it with hot water, let sit for 30 seconds, then empty it before beginning to brew.
NOTE: Opening the lid during the brew will stop water flowing into the funnel. Coffee will stop flowing out of the funnel when drip-out is complete.
FOR SPEED BREW MODELS: (Excluding Thermal models)
FOR THERMAL MODELS:
Important: Do not use an abrasive device to clean the carafe, because it will scratch the stainless steel. Occasionally, remove the brew-through valve on the Thermal Carafe lid and clean it with mild, non-abrasive detergent. To remove the valve, lift at the edge and pull up. Be sure to clean the passage where the valve is located (the valve is not on all models).
Cleaning the sprayhead tube removes deposits formed by natural mineral content in your water. The more mineral content in your water, the more you should clean.
A good rule of thumb is to clean it every 3 months. If you have very hard water, then twice a month may be necessary.
You will need a toothpick, dish soap, and a soft cloth.
NOTE: For a replacement sprayhead, call customer service at 1- 800-352-2866 (USA) or 1-800-263-2256 (Canada).
Routinely clean your coffee maker every 3 months. More frequency may be needed, depending on the mineral content in your water. Routine cleaning of your coffee maker removes mineral deposits in the internal hot water tank and will prolong the life of your coffee maker.
You will need:
WATER IN THE COFFEE MAKER SHOULD BE DRAINED WHEN THE COFFEE MAKER IS:
Bunn-O-Matic Corporation (“BUNN”) warrants the BUNN® Speed Brew Coffee maker, except glass carafe, to be free from defects in materials and workmanship existing at the time of manufacture and appearing within the later of the following warranty periods:
If such a defect appears during the warranty period, we will (at our sole option) repair or replace the defective Coffee maker with no charge for service or parts, provided the Coffee maker is delivered at the customer’s expense to one of our authorized service centers (see page 4 for customer service info).
Warranty does not cover claims resulting from misuse, failure to follow instructions on installation and use, use with water having a high mineral content, neglect, use of unauthorized attachments, commercial use, use on a current or voltage other than specified on the Coffee maker, or unauthorized service during the warranty period on conditions otherwise covered by warranty.
THIS WARRANTY SHALL BE EXCLUSIVE AND SHALL BE IN LIEU OF ANY OTHER WARRANTY, WRITTEN, ORAL, OR IMPLIED INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. In any event, the duration of any warranties implied by law, including but not limited to any implied warranties of merchantability or fitness for a particular purpose, is expressly limited to the duration of this limited warranty. Some states do not allow time limitations on implied warranties, so the above limitation may not apply to you.
THE CUSTOMER’S EXCLUSIVE REMEDY FOR BREACH OF THIS WARRANTY OR OF ANY IMPLIED WARRANTY, OR OF ANY OTHER OBLIGATION ARISING BY OPERATION OF LAW OR OTHERWISE, SHALL BE LIMITED AS SPECIFIED HEREIN TO REPAIR OR REPLACEMENT, AT OUR SOLE OPTION. IN ANY EVENT, RESPONSIBILITY FOR SPECIAL, INCIDENTAL, AND CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED. Some states do not allow limitation or exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
This warranty gives you specific legal rights; you may have other rights, which vary from state to state.
BUNN Pour-O-Matic, BUNN, BUNN with the stylized red line, The Horizontal Red Line, Bunn-OMatic, Bunn-O-Matic, Velocity Brew, My Café, Speed Brew, Phase Brew, trifecta, Air Infusion, Quality Beverage Equipment Worldwide, The Mark of Quality in Beverage Equipment Worldwide, A Partner You Can Count On, Brew Better Not Bitter, Brew better, not bitter., Coffee At Its Best, Nothing Brews Like a BUNN, Respect Earth, Respect Earth with the stylized leaf, and coffee cherry design, are either trademarks or registered trademarks of Bunn-O-Matic Corporation.
Clean the outside of the carafe with a damp cloth. DO NOT IMMERSE THE CARAFE IN WATER OR ANY OTHER LIQUID.
The BUNN BTXB Thermal Carafe Home Coffee Brewer is designed to reduce mineral build-up and eliminate the need for descaling. If you choose to descale your brewer, please follow the directions below. DO NOT DISASSEMBLE THE BREWER. DO NOT USE ALCOHOL OR ABRASIVE CLEANERS ON ANY PART OF THE BREWER.
1. Remove the carafe from the unit and rinse it thoroughly with hot water.
2. Fill the water tank with a solution of one part white vinegar to five parts water.
3. Place a paper filter in the basket and add 2 tablespoons of white vinegar to the filter and discard coffee grounds from previous brew cycle.
4. Turn on the brewer and run until all of the vinegar solution has been dispensed into a cup or glass, about 5 minutes. Discard paper filter after use.
5. Rinse carafe thoroughly with hot water and wipe dry with a soft cloth or paper towel, if necessary.
6. Replace carafe on brewer, making sure it is securely seated on base before plugging in brewer for operation (see Initial Setup section).
On the base of the carafe, I discovered a made in China sticker. Designed and assembled in the US, the packaging boasts. weak word choice.
Coffee with a temperature between 150 and 180 degrees is the most popular. For at least a few hours, a thermal carafe with good insulation can hold coffee at or above these temperatures.
It essentially prevents cold or hot air from entering the carafe and maintains heat trapped inside of it. In contrast to a glass carafe, its double-walled construction can keep your coffee hot for hours.
The coffee maker must first bring the coffee to the proper temperature before it can be kept there in a thermal carafe. Coffee should be brewed between 195 and 205 degrees Fahrenheit for the optimum extraction (4), but not all drip brewers meet this requirement.
A double-walled container with a pour server is known as a thermal carafe. Stainless steel is the material of choice. A vacuum exists between the walls to minimise convectional heat transfer. The contents of the thermal carafe pour servers can maintain heat for hours with very little heat loss.
Keurig 2.0 K-Cup Pod Coffee Maker Compatible with Keurig 2.0 Thermal Carafe 32oz Double-Walled, Vacuum-Insulated, Holds and Dispenses Up to 4 Cups of Hot Coffee, Stainless Steel.
Water, coffee, wine, and other beverages are served in carafes, which are often made of glass or metal and have handles. For warming purposes or as an additional container for serving, many individuals use a carafe to hold their freshly brewed coffee.
Put hot water in and leave the device standing for three to five minutes. Fill the container to the top with the hot beverage before serving. To keep liquid and temperature inside, tighten the lid.
Download PDF Link; BUNN Thermal Carafe Home Coffee Brewer pdf
SFB12CRX Daily Glow Kit IMPORTANTSAFET Y INSTRUC TIONS When using electrical appliances, especially when children…
AR15_D-Hop E-Reading Floor Lamp AR15_D/Hop e-Reading Lamp BenQ.com © 2022 BenQ Corporation. All rights reserved.…
FIN-180P FRESH IN Premium Supply Fan FRESH INTM PREMIUM FIN-180P AND FIN-180P-HW INSTALLATION INSTRUCTIONS RESIDENTIAL…
XCPSK67WW PRO 12V LED Strip Light Kit INSTALLATION & OPERATING INSTRUCTIONS Product Name: General information…
Neomounts NOTEBOOK-D100 Laptop Mount Product Layout PARTS How to Mount the Stand The steps are…
UM3074 X-NUCLEO-OUT19A1 Industrial Digital Output Expansion Board UM3074 User manual Getting started with the X-NUCLEO-OUT19A1…