GODOX RT-16 bežični set za blic - uputstvo za upotrebu

Uvod

The GODOX RT-16 Wireless Flash Trigger Set is designed to provide reliable wireless synchronization for studio monolights and strobe flashes. Operating on a 433MHz frequency, it offers 16 selectable channels for interference-free operation. This set includes one transmitter and one receiver, enabling remote control of your flash units.

The system supports a synchronization speed of up to 1/200s and has a wireless control range of up to 30 meters. It is compatible with a wide range of camera brands including Fujifilm, Canon, Nikon, Olympus, and Pentax. Please refer to the compatibility list for specific models.

Note: This product is not compatible with Sony MI hotshoe cameras or Canon 1500D, 3000D, and 200D Mark II models.

Setup

1. Instalacija baterije

The transmitter requires a 12V 23A battery, and the receiver requires two AAA batteries (not included). Ensure correct polarity when inserting batteries.

Image: Transmitter battery compartment. The transmitter uses a 12V 23A battery. Remove the screw under the 'QC PASS' label to access the compartment.

Image: Receiver battery compartment. The receiver requires two AAA batteries. Ensure to remove any insulating film if present before inserting batteries.

2. Podešavanje kanala

Both the transmitter and receiver feature dip switches to select one of 16 available channels. For proper operation, ensure both units are set to the same channel.

Image: Channel selection diagram. This diagram illustrates how to set the dip switches on both the transmitter and receiver to match one of the 16 available channels.

3. Connecting to Equipment

Mount the transmitter onto your camera's hotshoe. Connect the receiver to your studio strobe or monolight using the appropriate sync cable. The receiver has a 3.5mm jack, and a 3.5mm to 6.35mm adapter is included for compatibility with larger sync ports.

Image: Transmitter on camera and receiver connected to a studio strobe. This shows the typical setup for using the RT-16 system.

Image: 6.35mm adapter connection. The included adapter allows the receiver to connect to strobes with a 6.35mm sync port.

Uputstvo za upotrebu

1. Uključite napajanje

Ensure both the transmitter and receiver are powered on using their respective ON/OFF switches.

2. Probno paljenje

Press the test button on the transmitter to verify that the connected flash unit fires. The indicator light on the receiver should illuminate when a signal is received.

3. Camera Synchronization

Once the transmitter is mounted on your camera's hotshoe and the receiver is connected to your flash, take a picture. The flash unit should fire in sync with your camera's shutter.

4. Multiple Receivers

One RT-16 transmitter can control multiple RT-16 receivers simultaneously, provided all units are set to the same channel. This allows for multi-light setups.

Image: Multiple receiver setup. Illustrates how a single transmitter can wirelessly trigger multiple flash units equipped with RT-16 receivers.

Održavanje

1. Zamjena baterije

When the indicator light on the transmitter or receiver becomes dim or the units fail to trigger reliably, it is time to replace the batteries. Refer to the battery installation section for guidance.

2. Čišćenje

Za čišćenje vanjske strane odašiljača i prijemnika koristite meku, suhu krpu. Izbjegavajte upotrebu jakih hemikalija ili abrazivnih materijala.

3. Skladištenje

When not in use for extended periods, remove batteries from both units to prevent leakage. Store the set in a cool, dry place away from direct sunlight and extreme temperatures.

Rješavanje problema

• Blic se ne aktivira:
  • Provjerite da li su i predajnik i prijemnik uključeni.
  • Provjerite da li su oba uređaja postavljena na isti kanal.
  • Check battery levels in both units and replace if necessary.
  • Confirm the receiver is securely connected to the flash unit's sync port.
  • Ensure the transmitter is properly seated on the camera's hotshoe.
• Inconsistent firing:
  • Provjerite ima li potencijalnih smetnji od drugih bežičnih uređaja.
  • Smanjite udaljenost između predajnika i prijemnika.
  • Ensure there are no significant obstructions between the units.
• Problemi s kompatibilnošću:
  • Review the camera compatibility list provided in the setup section.
  • Note that Sony MI hotshoe cameras and specific Canon models (1500D, 3000D, 200D Mark II) are not supported.

Specifikacije

Image: Camera compatibility list. This table provides a detailed list of compatible camera brands and models for the RT-16 flash trigger.

Garancija i podrška

Za informacije o garanciji i tehničkoj podršci, molimo Vas da se obratite službenom GODOX-u. webweb-mjesto ili kontaktirajte prodavača. Sačuvajte račun za eventualne reklamacije.

You can find more information about GODOX products at the GODOX trgovina.