Braun Series 9 Manual

Braun Series 9

Braun Series 9 Manual

Braun Infolines Lignes d’assistance Braun

Thank you for purchasing a Braun product. We hope you are completely satisfied with your new Braun shaver.

If you have any questions, please call:
US residents 1-800-BRAUN-11
1-800-272-8611
Canadian residents 1-800-387-6657

Inside the pack

Using

setting

IMPORTANT SAFETY INSTRUCTIONS
(models 9090cc/9075cc/9070cc/9050cc/9030cc)
When using an electrical appliance, basic precautions should always be followed,
including the following:

Read all instructions before using this appliance.
When disconnected, the hand-held part of this shaving appliance may be cleaned
under water.

DANGER
To reduce the risk of electric shock:
1. Use only in dry condition.
2. Do not submerge in water.
3. Do not reach for an appliance that has fallen into water. Unplug immediately.
4. Do not use while bathing or in a shower.
5. Do not place, store or charge the appliance where it can fall or be pulled into a tub or
sink. Do not place in or drop into water or other liquid.
6. Except when charging, always unplug this appliance from the electrical outlet
immediately after using.
7. Unplug this appliance before cleaning.
8. This appliance is provided with a special cord set with integrated Safety Extra Low
Voltage power supply. Do not exchange or manipulate any part of it.
9. Do not use an extension cord with this appliance.

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS
(models 9095cc w&d/9080s w&d/9040s w&d only)
When using an electrical appliance, basic precautions should always be followed,
including the following:

Read all instructions before using this appliance.
When disconnected, the hand-held part of this shaving appliance may be used in a
bath or shower. For safety reasons, the appliance can only be operated cordlessly.

DANGER
To reduce the risk of electric shock:
1. The charger unit is not for immersion in water or for use in shower.
2. Do not reach for a charger that has fallen into water. Unplug immediately.
3. Do not place, store or charge the appliance where it can fall or be pulled into a tub or
sink. Do not place in or drop into water or other liquid.
4. Except when charging, always unplug this appliance from the electrical outlet
immediately after using.
5. This appliance is provided with a special cord set with integrated Safety Extra Low
Voltage power supply. Do not exchange or manipulate any part of it.
6. Do not use an extension cord with this appliance.

WARNING (all models)
To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Close supervision is necessary when this appliance is used by, on, or near children or
persons with disabilities.
2. Use this appliance only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
3. Never operate this appliance if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or if the power supply has been dropped
into water. Return the appliance to a service center for examination and repair.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any opening of the appliance.
6. Do not use outdoors or operate where aerosol (spray) products are being used or where
oxygen is being administered.
7. Do not use this appliance with a damaged or broken foil, as serious skin injuries may
occur.
8. Always attach plug to appliance first, then to outlet. To disconnect, turn all controls off,
then remove plug from outlet.
9. When plugging to an electrical outlet outside North America, use a plug adapter to
match the outlet’s pin configuration.
10. Caution: The battery used in this device may present a fire or chemical burn hazard if
mistreated. Do not disassemble, heat above 100 °C (212 °F), or incinerate.
11. Only use the special electric cord set provided with the appliance.
12. Oil bottle (models 9080s/9040s/9030s only)
Keep out of reach of children. Do not swallow. Do not apply to eyes. Dispose of properly when empty.

Our products are designed to meet the highest standards of quality, functionality and design.
Thank you for your trust in Braun’s quality, and we hope you enjoy your new Braun shaver.

Warning
Only models 9080s/9040s w&d can be used with foam or gel.
Clean&Charge Station (models 9095cc w&d/9090cc/9075cc/9070cc/9050cc)

To prevent the cleaning fluid from leaking, ensure that the Clean&Charge Station is placed on a flat surface. When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge. Do not place the station inside a mirror cabinet, nor place it on a polished or lacquered surface.

The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition. Do not expose to direct sunlight and cigarette smoking nor store it over a radiator. Do not refill the cartridge and use only original Braun refill cartridges.

Shaver
1 Foil & Cutter cassette
2 Cassette release buttons
3 MultiHeadLock switch
4 On/off switch
5 Shaver display
6 Long hair trimmer
7 Shaver-to-station contacts
8 Release button for long hair trimmer
9 Model number of shaver
10 Shaver power socket
11 Special cord set
12 Brush
13 Hard travel case

Manual cleaning of the shaver
(see fig. B/C)
Cleaning under running water

• Switch on the shaver (cordless) and rinse the shaver head under hot running water until all residues have been removed. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.

• Next, switch off the shaver, press the release buttons (2) to remove the Foil & Cutter cassette (1) and let it dry completely.

• If you regularly clean the shaver under water, then apply once a week a drop of light machine oil on top of the Foil & Cutter cassette. Models 9080s w&d/9040s w&d only: The shaver should be cleaned after each foam usage.

Cleaning with a brush
• Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. Do not clean the cassette with the brush as this may damage it! The Foil & Cutter cassette can be attached either way. There is no impact on the shaving performance.

The Clean&Charge Station has been developed for cleaning, charging, lubricating, disinfecting, drying and storing your Braun shaver.
14 Station power socket
15 Lift button for cartridge exchange
16 Station-to-shaver contacts
17 Clean&Charge Station display
17a Level indicator
17b Status light
17c Cleaning program indicator (models 9095cc w&d/
9090cc/9075cc only)
18 Start button
19 Cleaning cartridge

Installing the Clean&Charge Station (see fig. D)
• Remove the protection foil if any from the Clean&Charge Station display.
• Press the lift button (15) at the rear side of the Clean&Charge Station to lift up the housing.
• Hold the cleaning cartridge (19) down on a flat, stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge from the rear side into the base of the station until it snaps into place.
• Slowly close the housing by pushing it down until it locks.
• Connect the station to an electrical outlet by snapping the special cord set (11) into the power socket (14).

Charging the shaver in the Clean&Charge Station (see fig. D)
Insert the shaver head with the front showing and released head lock into the cleaning station.

Important: The shaver needs to be dry and free from any foam or soap residue!
The contacts (7) on the back of the shaver need to align with the contacts (16) in the station. Push the shaver in the correct position. A beep sound confirms that the shaver sits properly in the station. Charging will start automatically.

Cleaning the shaver (see fig. D)
When the cleaning indicator lights up in the shaver display, insert the shaver into the Clean&Charge Station, as described above and press the start button (18).

The hygiene status will be analyzed and is shown by the cleaning program indicators (17c) in the Clean&Charge Station display (models 9095cc w&d/9090cc/9075cc only).

If status light (17b) does not shine (Clean&Charge Station switches to stand-by after ca. 10 minutes), press start button twice. Otherwise cleaning will not start. For best shaving results, we recommend cleaning after each shave.

The cleaning process consists of several cycles, in which cleaning fluid is flushed through the shaver head. Depending on your Clean&Charge Station model and/or program selected, the cleaning time takes up to 3 minutes, followed by an active drying phase of about 40 minutes, during which a fan is running.

Afterwards charging will resume, which is indicated in the shaver display. When the shaver is fully charged the display turns off.

Cleaning programs
Models 9095cc w&d/9090cc/9075cc:
*short economical cleaning
**normal level of cleaning
***high intensive cleaning
Models 9070cc/9050cc:
One standard cleaning program is included.

Removing the shaver from the Clean&Charge Station (see fig. E)
Hold the Clean&Charge Station with one hand and tilt the shaver slightly to the front to release it.

Cleaning Cartridge / Replacement (see fig. F)
When the level indicator (17a) lights up permanently red, the remaining fluid in the cartridge is sufficient for about 3 more cycles. When the level indicator blinks red, the cartridge needs to be replaced (about every 3 weeks when used daily).

After having pressed the lift button (15) to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.

The hygienic cleaning cartridge contains denatured ethanol (specification see cartridge), which once opened will naturally evaporate slowly. Each cartridge, if not used daily, should be replaced after approximately 8 weeks to ensure optimal disinfection.

The cleaning cartridge also contains lubricants for the shaving system, which may leave residual marks on the outer foil frame and the cleaning chamber of the Clean&Charge Station. These marks can be removed easily by wiping gently with a damp cloth.

Accessories
Braun recommends changing your shaver’s Foil & Cutter cassette every 18 months to maintain your shaver’s maximum performance.

Available at your dealer or Braun Service Centres:
• Foil & Cutter cassette: 90S/90B
• Cleaning cartridge Clean&Charge Station: CCR
• Braun Shaver cleaner spray

Environmental notice
This appliance contains rechargeable batteries. To protect the environment, do not dispose of the appliance in the household waste at the end of its useful life.

Disposal can take place at a Braun Service Center or appropriate collection sites.

The cleaning cartridge can be disposed of with regular household waste.

Subject to change without notice. For electric specifications, see printing on the special cord set.

Please note down the suggested replacement date (in 18 months from now) below replacement part reference number.

Trouble-Shooting

Leave a Reply

Your email address will not be published. Required fields are marked *