Bona’ Premium Spray Mop for Hard-Surface Floors
A. Upper Spray Mop Handle
B. Lower Pole with Cartridge Enclosure
C. Mop Base
D. Bona Microfiber Cleaning Pad
E. Bona Floor Cleaner Cartridge
The silver Cartridge Release Button on the Lower Mop Pole (B) (Fig A) and the Bona logo on the mop base (C) should both be facing the front. Ensure that the swivel knuckle on the mop pole is facing down before attachment. Attach mop pole to mop base by aligning recessed slots in knuckle with tabs of similar size in mop base (Fig B). Push to connect. Attachment should happen without excessive force. If not, tabs and recesses may not be aligned correctly.
Attach Upper Spray Mop Handle (A) to Lower Pole with Cartridge Enclosure 03) by aligning similar profiles of the poles and pushing together until a click is heard. Attach Bona. Microfiber Cleaning Pad to Mop Base by plating pad on the floor with the printed side facing up. Place the mop base o‘er the center of the pad and press down firmly to attach. The Bone logo on the Mop Base should face forward while mopping.
Remove the cap from the cleaning cartridge, and engage into the cartridge endorsed by pushing in until a click Is heard. Your mop is now ready to use! When the cartridge is empty. press the SINtf cartridge release button to disengage the cartridge before refilling.
Cleaning the Microfiber Pads
Wash .n warm water
Air or tumble dry low
DO NOT use bleach
DO NOT use fabric softeners
DO NOT wash with articles that shed lint
Documents / Resources
|Bona Premium Spray Mop for Hard-Surface Floors [pdf] User Manual|
Premium Spray Mop for Hard-Surface Floors