Model: Faith 2
Welcome to your new Bluedio headphones
We appreciate your choice of Bluedlo headphones. Before use, please read this user manual carefully and keep for future reference.
You can find the verification code by scraping the coating off the security label that is affixed to the original packaging. Enter the code on our official website: www.bluedio.com for purchase verification.
Learn more and get support
Welcome to visit our official website: www.bluedio.com; Or to email us at firstname.lastname@example.org; Or to call us at 020-88062628-835.
Important Safety Information
In the Box
When the headset is off, press and hold the MF button until you hear “Power on”, and you will one the blue light blinks. Note: The ANC function must be turned off before turning on the headphone under Bluetooth mode.
When the headset is on, press and hold the MF button until you hear “Power or. Pairing: When the headset is off, press and hold the MF button until you hear “Ready to pair”, and you will one the blue light stays on.
Answer/Reject phone calls:
Receiving an incoming call, press the MF button once to Answer; press once again to End; Press and hold for 2 seconds to refuse.
Switch phone calls:
Receiving Call 2 in Call 1, press and hold the MF button to hold on Call 1 and answer Call 2; press and hold again to switch back to Call 1; press once to end the call.
Radial the last number:
Press the MF button twice to redial the last number.
When playing music, press the MF button once to Pause/Play.
Make the headset enter pairing mode (see instruction “Pairing”), and tum on the Bluetooth feature of your phone, select ‘Bluedio F”; you will hear “device connected” after successfully paired.
Note: If pairing is not successful within 2 minutes, please repeat above steps to pair again.
Press once to reduce the volume; press and hold to skip to the previous track.
Press Once to increase the volume; Press and hold skip to next track.
Push the ANC switch to turn on/off the ANC function; when it’s on, the green light will stay on.
Turn on the headset first, then press the MF button and the Volume- button once simultaneously to select English/Chinese/ French/Spanish.
Connect to two mobile phones via Bluetooth:
Line-In music playback:
Use the standard 3.5mm Type-C audio cable to connect the headphones with your mobile phone and computer.
Note: Turn off the headphone befor using this feature.
Line-out music playback:
Connect the headphones with your mobile phone via Bluetooth first, then use the 3.5mm Type-C audio cable to connect the headphones with other headphones.
Note: Turn off the ANC function before using this feature.
Charger and battery
Charging cable: please use the Included Type-C charging cable to charge the battery, or it may damage the headphones.
USB wall Charger: if using a USB wall charger, the output requires 5VDC, > 0.5A.
Charge the headphones
The built-in battery is rechargeable and non-detachable. Don’t try to replace the battery on your own. Turn off the headphones before charging.
Use the included Type-C charging cable to connect the headphones with a computer or wall charger. While charging, the red light stays on.
Allow 1.5 hours for a full charge. Once fully charged, the blue light will stay on.
Specifications are subject to change without notice.
Questions about your Manual? Post in the comments!
USER MANUAL KRG Sigfox SeniorAdom GPS Tracker Model: DS-3423ST-00 DESCRIPTION KRG GPS tracker is designed…
USER MANUAL Infrared Thermal Image Detector Model: HG-T01 V1.1 Symbol Description Attention refers to the…
USER MANUAL SIERRA WATER RESISTANT SPEAKER Model: MI-S047B-101 INCLUDES: • SIERRA Speaker • Micro USB…