BISSELL 2982F Pet Stain Eraser PowerBrush



  • Upon removing your machine from the box, insert the charger
    • For a maximum run time, charge the machine for 4.5 hours prior to use
      • Note: It could take up to 2 hours for the machine to go from 1 to 2 battery lights while charging

Battery Light Indication


Battery Charge Percentage



No Battery Lights



Machine is powered off/ Machine is fully charged if plugged in



One Battery Light Breathing



1%-14% charged



One Battery Light Solid, One Breathing Battery Light



15%-69% charged



Two Solid Battery Lights, One Breathing Battery Light



70%-90% charged



Three Solid Battery Lights



Fully Charged


Battery Light Indication


Battery Charge Percentage



One Battery Light Blinking



Battery Below 15% > Plug into Charge

Formula Tank

  • Open Formula Tank Cap and fill with Formula to the Formula dot
  • Close Formula Tank Cap until it clicks and is securely closedBISSELL-2982F-Pet-Stain-Eraser-PowerBrush-fig-7


  • Turn Machine on
    • Brush Roll will automatically start spinning, to turn Brush Roll off hit the Brush Roll buttonBISSELL-2982F-Pet-Stain-Eraser-PowerBrush-fig-8
  • Spray Formula in the desired area using the Spray ButtonBISSELL-2982F-Pet-Stain-Eraser-PowerBrush-fig-9
  • Scrub the area with the rotating PowerBrush
    • Keep the nose of the machine flat on the surfaceBISSELL-2982F-Pet-Stain-Eraser-PowerBrush-fig-10
  • For best suction, tilt the machine slightly forward and pull backward while firmly pressing the suction channel to the cleaning areaBISSELL-2982F-Pet-Stain-Eraser-PowerBrush-fig-11
  • Make sure to empy the Dirty Tank when it reaches the MAX FULL line
    • For instructions on Emptying the Dirty Water Tank > Go to After Cleaning CareBISSELL-2982F-Pet-Stain-Eraser-PowerBrush-fig-12

Documents / Resources

BISSELL 2982F Pet Stain Eraser PowerBrush [pdf] User Guide
2982F, Pet Stain Eraser PowerBrush, 2982F Pet Stain Eraser PowerBrush


Leave a comment

Your email address will not be published.