beFree Sound BFS-400 Blue 5.1 Channel Surround Sound BT
Spactar;Systom

Thank you for choosing BeFree Sound Please read this manual carefully and keep it for future reference
NOTE: This unit is set on 5.1 mode upon startup, please press the5.1/2.1 button for 2.1 surrond sound
Usage:

Specification:

Frequency Response:40Hz-20KHz
“Separation 5048
“Speaker: 4425 x5
Caution.

1. D0 not expose 1o dripping or splashing
2. D0 not place any objects fillad with water over the apparatus,
3. D0 not lock the ventilation holes,
4. Forindoor use only
5. When using high output signal don’turn the volume to maximum 10 avoid distortion.

Inside Package:

How to use the BT:

1. select the audio input to BT status
2. search BT device with the name “BFS-400” on the device you want to pair
3. connect the BT
4. if your BT devise is below the 2.0 version, input password “0000” when connecting.

Frontpanel

Front panel

INPUT Input function key, switch among AUX/USB/SD/FM mode; Select Standby function by pressing this button for 3 seconds when the unit is in AUX/USB/SD/FM mode.
VOLUME-/+ Rotate to the left to lower the volume Rotate to the right to lower the volume
5.1/2.1 5.1/2.1 function key.
AUTO USB/SDpause/Play function key. Automatically searches FM Stations when in FM Mode
CH- Previous song in USB/SD mode.
Previous saved channel in FM mode.
CH+ Next song in USB/SD mode. Next saved channel in FM mode
. U DISK USB disk slot SD/MMC CARD SD / MMC card slot

System connection diagram

SPEAKER TERMINALS
SPEAKER TERMINALS Connect front speakers, a center speaker,surround speakers to 5.1 speaker output terminals.
-The front speaker cords to the FRONT SPEAKERS terminals
-The center speaker cords to the CENTER SPERKERS terminals -The surround speaker cords to the SURROUND SPEAKER terminals
NOTE: *Do not leave objects generating magnetism near the speakers.

Connecting equipment
Jacks and plugs of the connecting cord are color-coded as follows: Red jacks and plugs: For the left channel of audio signals
NOTE: Insert the plugs fully into the jacks. Loose connections may produce a humming sound or other noise interference.
Important: First, connect the speakers and all other external equipment, and finally connect the AC power cord

How to use the remote control

FLERSE NOTE. i 4 tmois coil 51 fncioning, peiss eplacoe btteries.

Positioning the speakers

a Sub-woofer Place the sub-woofer any place on the floor (There is no directional requirement for the Bass effect)
b Front Speakers
c Surround Speakers Place the surround speakers directly to the side behind the listening area Align them horizontally, about 1 meter above ear level
d Center Speakers Position in the center of the two front speakers in addition position on or below the TV set, if connecting a TV set to the unit

Documents / Resources

beFree Sound BFS-400 5.1 Channel Surround Sound BT Speaker System [pdf] Instruction Manual BFS-400 5.1 Channel Surround Sound BT Speaker System, BFS-400, 5.1 Channel Surround Sound BT Speaker System, Surround Sound BT Speaker System, Sound BT Speaker System, BT Speaker System, Speaker System

References

• User Manual