İstifadəçi Təlimatı Q&ACavab verin
26 iyun 2025-cü il - 04:08
Sizin qurmaq üçün REC WiFi Modulu ilk dəfə bu addımları yerinə yetirin:
1. Connect the module to your REC BMS device via the included RS-485 connection harness.
2. Connect the power supply to the REC WiFi Module, ensuring it falls within the specified power supply restrictions mentioned in Table 1 of the user manual.
3. If it's your first time connecting the module, it will set up an access point with default credentials (SSID: REC_BMS, PASS: none). If this doesn't happen, reset the device by holding the factory reset button for 20 seconds.
4. Using a WiFi-supported device, connect to the access point named REC-BMS_AP.
5. Open your browser and type in the IP address 192.168.1.184 in the address bar. This should open the Main Menu, displaying your battery pack status. If you see "REC BMS not found," you'll need to set up your communication parameters as per the manual instructions.
By following these steps, you should be able to successfully set up and access your REC WiFi Modulu for monitoring and configuring your battery pack.
Yeni Şərh əlavə edin