KRAMER -KRT-4-M1 -Table- Mounting- Bracket
Qutuda nə olduğunu yoxlayın
- KRT-4-M1 Stolun montaj braketi
- 3 M4x13 Fully threaded screws for wood
- 1 Sürətli başlanğıc təlimatı
Get to know your KRT-4-M1
KRT-4-M1 Table Mounting Bracket enables attaching the KRT-4 Cable Retractor to the underside of a table. KRT-4-M1 is designed mainly for RTBUS and TBUS product lines with cable pass-through.
Install KRT-4-M1
Before installing KRT-4-M1, configure and mount a Kramer TBUS onto a table. To attach KRT-4-M1 to the underside of a table:
- Attach KRT-4-M1 Table Mounting Bracket to the cable retractor using the Wing-Head thumb screw (see figure).
- Position KRT-4-M1 and cable retractor underneath the table in a position close to the Kramer TBUS, ensuring that the non-retractable cable end of the cable retractor reaches the TBUS.
- Mark the edges where KRT-4-M1 touches the table with a pencil.
- Detach KRT-4-M1 from the cable retractor.
- Place KRT-4-M1 so that it aligns with the pencil markings made in step 3, and using the 3 screws provided, attach KRT-4-M1 to the underside of the table.
Take care not to damage the table. Kramer Electronics is not responsible for any damage caused to the table. - Attach the cable retractor to KRT-4-M1 Table Mounting Bracket using the Wing-Head Thumb Screw.
Texniki xüsusiyyətlər bildirilmədən dəyişdirilə bilər www.kramerav.com
Sənədlər / Resurslar
 |
KRAMER KRT-4-M1 Table Mounting Bracket [pdf] İstifadəçi Təlimatı KRT-4-M1 Table Mounting Bracket, KRT-4-M1 Table mount bracket for KRT 4, KRT-4-M1, Table Mounting Bracket |
