AUDIO SYSTEM M100, 130, 165, 200 2 Way Component System
PARTS & TOOLS
Congratulations on purchasing a high-quality
AUDIO SYSTEM product incl. GERMAN SOUND. Important: Completely read this operating instruction before installation and use of the device.
Attention: Pay attention to advice and instructions of the car manufacturer. Check the polarity when connecting the speakers.
Important: You will need your purchase receipt as proof of purchase for all warranty repairs and for insurance purposes. Keep your receipt, owner´s manual and packing materials in a safe location for possible future use.
Attention: Use of sound components can impair your ability to hear necessary traffic sounds and may constitute a hazard while driving your automobile. AUDIO SYSTEM GERMANY accepts no liability for hearing loss, bodily injury, or property damage because of use or misuse of our products.
We recommend installing the equipment by an authorized service center or dealer. A professional fitting and connection are the requirement for further warranty and perfect sound.
Mechanical Installation Tip
Warning: First disconnect negative pole of your car battery. Check-polarity, changing polarity may cause serious damage to your car electric. Best speaker positions are the original build in positions. Easy installation and original look are the reasons. Please note that the speakers are installed flat and stable. The quality of the installation decides the sound very much, therefore, attention should be paid to insulation and care during installation. Please note that the speakers are protected from heat, sunlight, mechanical influences, moisture and wetness by accessories from AUDIO SYSTEM.
Attention: Install all cables as straight as possible without squashing or laying them over sharp edges. Otherwise, this can cause short circuit or damages to your whole installation.
Attention: Be careful removing original plastic parts of your car. The fitting parts could be damaged and must be replaced. Important: The right polarity of all speakers is extremely important for the sound of your car audio system. We recommend changing polarity of the tweeter finding out the best possible sound.
The best is to listen and/or to measure it.
The tweeter has 2x special mounting brackets that you can use for optimal installation.
Look/Unlock Tool Tweeter
The attached lock/unlock tool is designed to fit in the holes of the tweeter-grille. Turning the tweeter to the left will lock the tweeter into the housing, turning to the right will unlock the tweeter.
Tweeter (Crossover FWK TW)
Important: The speaker system can be adapted to the acoustics of the vehicle, the genre of music and to the personal taste via the crossover. Depending on the position of the speakers, the switch can be adjusted so that the frequency response is optimized with these geometric conditions. Depending on the installation location of the tweeter, it is necessary to adjust the frequency response tonal and volume technology, e.g., when mounting the tweeter in the A-pillar, in the mirror triangle or in the door trim.
Attention: Free cable ends must be isolated.
Non-compliance can lead to a short circuit!
|Red (4.8mm Plug)||Input +||To SPEAKER +|
|Black (2.8mm Plug)||Input –||To SPEAKER –|
|Red (Round Sleeve)||Tweeter +||Connect to Tweeter +|
|Black (Round Plug)||Tweeter –||Connect to Tweeter –|
|Jumper 2,7µF + Parking||-3dB (2.7µF)||Tweeter in Mirror Cover|
|Jumper 3,9µF + Parking||0dB (3.9µF)||Tweeter in Door Panel|
|Jumper 2,7µF + 3,9µF||+3dB (6.6µF)||Tweeter in A-Pillar|
Optional Mounting Accessories
- Self Adhesive Damping Material ALUBUTYL 1500, 2000 EVO, 3000 EVO and ALU 250 EVO
- Damping: DOORKIT 1.0 and DOORKIT 2.0
- Sound Guidance Ring: Z-SFR 100/130/165/200
- Rain Protection: MBR 165/200
- Z-(T)SC 0.75, 1.5, 2.5, 4.0 Oxygen-Free Speaker Cable
Documents / Resources
|AUDIO SYSTEM M100, 130, 165, 200 2 Way Component System [pdf] User Manual|
M100 130 165 200 2 Way Component System, M100, M130, M165, M200, M100 2 Way Component System, M130 2 Way Component System, M165 2 Way Component System, M200 2 Way Component System, 2 Way Component System, 2 Way System