Introduction
Thank you for choosing the Srivdk Cordless Water Dental Flosser. This device is designed to enhance your oral hygiene routine by effectively cleaning between teeth and below the gumline, where traditional brushing and flossing may not reach. Please read this manual thoroughly before first use to ensure safe and optimal operation.
Safety Information
- Do not immerse the charging cable or adapter in water.
- Ensure the charging port cover is securely closed before using the device in wet environments.
- Keep out of reach of children.
- Consult a dentist before use if you have any oral health concerns.
- Statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition.
Package Contents
Verify that all items are present in your package:
- 1x Srivdk Cordless Water Dental Flosser Unit
- 6x Replaceable Jet Tips (various types for different needs)
- 1x USB Type-C Charging Cable (adapter not included)
- 1x Sponge Cleaning Stick
- 1x User Manual
Setup
- Charge the Device: Before first use, fully charge the water flosser. Connect the provided USB Type-C charging cable to the device and a compatible USB power adapter (not included). A full charge takes approximately 3 hours and provides up to 30 days of use.
Image: The water flosser connected to a USB-C charging cable, illustrating the charging process. - Attach a Jet Tip: Select your desired jet tip. Insert the tip into the hole at the top of the flosser handle until it clicks into place. To remove, press the release button on the side of the handle and pull the tip out.
Image: A display of six different interchangeable jet tips: three standard tips for daily cleaning, one periodontal tip for gum pockets, one orthodontic tip for braces and implants, and one tongue scraper. - Fill the Water Tank: Twist the water tank counter-clockwise to detach it from the main unit. Fill the tank with warm water. You may also use diluted mouthwash. Reattach the tank by twisting it clockwise until secure.
Image: A hand detaching the 300ml water tank from the main unit and filling it with water from a faucet, highlighting its easy-to-fill and easy-to-clean design.
Operating Instructions
- Select a Mode: The device features three cleaning modes:
- Soft Mode: Ideal for beginners, sensitive gums, or children.
- Strong Mode: For deep cleaning and effective plaque removal.
- Pulse Mode: Provides gum massage and improves circulation.
Image: A close-up of the water flosser's control panel, illustrating the three distinct water pressure modes: Soft, Strong, and Pulse, each with a brief description of its intended use. - Position the Nozzle: Lean over a sink and place the jet tip into your mouth, aiming it at your gumline at a 90-degree angle.
- Start Flossing: Press the power button to turn on the device. Keep your mouth slightly open to allow water to flow into the sink. Guide the tip along your gumline, pausing briefly between teeth.
- Finish: When finished, press the power button again to turn off the device. Remove the tip and rinse it under warm water.
Maintenance
- Cleaning the Water Tank: After each use, detach the water tank and empty any remaining water. Use the provided sponge cleaning stick to clean the inside of the tank. Rinse thoroughly and allow to air dry.
- Cleaning the Main Unit: The device is IPX7 waterproof, allowing it to be safely rinsed under water or used in the shower. Wipe the exterior of the main unit with a soft, damp cloth. Do not use abrasive cleaners.
Image: The water flosser being used under running water, demonstrating its IPX7 waterproof capability for safe use in wet environments like the shower. - Replacing Jet Tips: For optimal performance and hygiene, it is recommended to replace jet tips every 2-3 weeks.
- Storage: Store the device in a cool, dry place away from direct sunlight.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not turn on. | Low battery or not charged. | Charge the device fully using the USB-C cable. |
| Weak water pressure. | Low battery, clogged tip, or incorrect mode. | Ensure device is fully charged. Clean the jet tip. Select a stronger mode (e.g., Strong or Pulse). |
| Water leakage from the tank. | Tank not properly secured. | Ensure the water tank is twisted clockwise until it is firmly attached to the main unit. |
Specifications
- Model: Water Flosser
- Water Tank Capacity: 300ml
- Water Pressure: 60-120 PSI
- Pulse Frequency: Up to 1800 times/min
- Charging: USB Type-C, 3 hours for full charge
- Battery Life: Up to 30 days on a single charge
- Waterproof Rating: IPX7
- Dimensions: 9.29 x 4.25 x 2.91 inches
- Weight: 12.31 ounces
- Manufacturer: Srivdk
Warranty and Support
For warranty information or product support, please refer to the contact details provided on the product packaging or visit the official Srivdk website. Keep your purchase receipt for warranty claims.
