1. Introduction
Thank you for choosing the GiveBest PTC910EO Portable Electric Space Heater. This manual provides essential information for the safe and efficient operation of your new heater. Please read it thoroughly before use and retain it for future reference.

Image 1.1: The GiveBest PTC910EO space heater, showcasing its compact design, digital display, and included remote control. The image also highlights its 70-degree oscillation capability.
2. Important Safety Instructions
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Always unplug heater when not in use.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
- Do not use outdoors.
- This heater is not intended for use in bathrooms, laundry areas, and similar indoor locations. Never locate heater where it may fall into a bathtub or other water container.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over.
- To disconnect heater, turn controls to OFF, then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/power strip).
- This heater is equipped with a tip-over safety switch. If the heater tips over, it will automatically shut off.
- The heater features overheat protection. If the heater reaches an unsafe temperature, it will automatically shut off.

Image 2.1: Visual representation of the multi-layer safety protections integrated into the GiveBest space heater, including 45-degree tip-over protection, V-0 flame retardant materials, child lock, overheat protection, a safety plug, and ETL certification.
3. Product Overview
The GiveBest PTC910EO is a portable electric space heater designed for indoor use. It features PTC ceramic heating technology, a digital display, thermostat, remote control, 70-degree oscillation, and a 12-hour timer.
Package Contents:
- GiveBest PTC910EO Space Heater
- Remote Control
- User Manual
Main Components:
- Digital Display Panel
- Control Buttons (on top of unit)
- Air Outlet Grille
- Air Intake (rear)
- Power Cord and Plug
- Base with Oscillation Mechanism

Image 3.1: The GiveBest space heater illustrating its compact dimensions (6.4"D x 6.4"W x 8.3"H) and the layout of its top-mounted control buttons.
4. Setup
Follow these steps to set up your heater for first use:
- Unpacking: Carefully remove the heater from its packaging. Retain the packaging for storage or future transport.
- Placement: Place the heater on a firm, level surface. Ensure there is at least 3 feet (0.9 m) of clear space around the heater from any combustible materials. Do not place it directly under a power outlet.
- Power Connection: Plug the power cord directly into a 120V AC, 60Hz wall outlet. Do not use extension cords or power strips.
5. Operating Instructions
The heater can be operated using the control panel on the top of the unit or the included remote control.
Control Panel & Remote Functions:
| Button/Function | Description |
|---|---|
| Power (On/Off) | Turns the heater on or off. |
| Mode | Cycles through heating modes: Power (High Heat), ECO (Energy Saving), and Fan Only. |
| Temperature (+/-) | Adjusts the desired temperature from 41°F to 95°F in 1°F increments. |
| Oscillation (OSC) | Activates or deactivates the 70-degree oscillation function for wider heat distribution. |
| Timer | Sets the auto-off timer for up to 12 hours. Press repeatedly to select desired duration. |
| Child Lock | Activates or deactivates the child lock feature to prevent accidental changes to settings. (Specific activation method may vary, typically press and hold a button or combination). |

Image 5.1: Overview of key operational features: 12-hour timer, 70-degree oscillation, remote control, three heating modes (Fan Only, Low Heat, High Heat), and the heater's portable design.
Initial Operation:
- Plug the heater into a suitable electrical outlet.
- Press the Power button on the control panel or remote to turn the unit on. The digital display will illuminate.
- The heater will typically start in a default heating mode. Use the Mode button to select your preferred setting (Power, ECO, or Fan).
- Adjust the desired temperature using the + or - buttons. The heater will cycle on and off to maintain the set temperature.
- Activate Oscillation if desired for wider heat distribution.
- Set the Timer if you want the heater to automatically turn off after a specific duration.

Image 5.2: The heater's digital display showing a set temperature of 95°F, with indicators for its precise temperature control range of 41°F to 95°F, supported by a dedicated thermal sensor.
ECO Mode:
In ECO mode, the heater automatically adjusts its power output to maintain the set temperature, optimizing energy consumption. This mode helps save energy while keeping your space comfortable.

Image 5.3: Illustration of the ECO mode, highlighting its energy-saving benefits (up to 40% on bills) by maintaining the ideal temperature, alongside the heater's adjustable temperature range of 41°F to 95°F.
6. Maintenance
Regular maintenance ensures optimal performance and longevity of your heater.
Cleaning:
- Always unplug the heater and allow it to cool completely before cleaning.
- Use a soft, damp cloth to wipe the exterior surfaces of the heater. Do not use abrasive cleaners or solvents.
- Gently vacuum the air intake and outlet grilles to remove dust and lint.
- The heater may have a detachable filter (check product specifications). If so, clean or replace it as per manufacturer guidelines.
Storage:
- Store the heater in a cool, dry place when not in use.
- It is recommended to store the heater in its original packaging to protect it from dust and damage.
7. Troubleshooting
If you experience issues with your heater, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Heater does not turn on. | No power, power switch off, tip-over switch activated, overheat protection activated. | Ensure plug is securely in outlet. Check if power switch is ON. Place heater on a flat, stable surface. Unplug and allow to cool for 30 minutes before restarting. |
| Heater produces no heat. | Fan Only mode selected, temperature setting too low. | Select a heating mode (Power or ECO). Increase the desired temperature setting. |
| Oscillation not working. | Oscillation function not activated. | Press the OSC button on the control panel or remote. |
| Heater makes unusual noise. | Dust/debris in fan, unit not on a level surface. | Unplug and clean air intakes. Ensure heater is on a stable, flat surface. If noise persists, discontinue use and contact support. |
| Remote control not working. | Batteries depleted, obstruction, remote out of range. | Replace remote control batteries. Ensure no obstructions between remote and heater. Operate remote within effective range. |
8. Specifications
| Feature | Detail |
|---|---|
| Model Number | PTC910EO |
| Brand | GiveBest |
| Power Output | 1500W |
| Heating Technology | PTC Ceramic |
| Voltage | 120V AC, 60Hz (Standard US) |
| Temperature Range | 41°F - 95°F |
| Oscillation Angle | 70° |
| Timer | Up to 12 hours |
| Product Dimensions | 6.4"D x 6.4"W x 8.3"H |
| Item Weight | 3.2 pounds |
| Safety Features | Tip-over Protection, Overheat Protection, V-0 Flame Retardant Material, Safety Plug, ETL Certified, Child Lock |
| Color | Grey |
9. Warranty and Support
GiveBest products are manufactured to high-quality standards. For information regarding warranty coverage, please refer to the warranty card included with your purchase or visit the official GiveBest website. If you encounter any issues or have questions about your product, please contact GiveBest customer support for assistance.
Customer Support: Please refer to the contact information provided on your product packaging or the official GiveBest website.