1. Introduction
This manual provides essential instructions for the proper use, setup, and maintenance of your VIVURN 028 Leg Exerciser Replacement RF Remote Control. Please read this manual thoroughly before use to ensure optimal performance and longevity of your device.
2. Compatibility
This replacement remote control is specifically designed for the VIVURN 028 White under desk elliptical. It is compatible with units ordered after October 1, 2025. This remote is not compatible with the VIVURN 018 mini elliptical or other brands of leg exercisers.
To confirm compatibility, press any button on the remote. The light in front of the remote should turn blue. Ensure your original remote exhibited this behavior.
Image: The VIVURN 028 replacement remote shown next to several elliptical models, highlighting its specific compatibility with the white VIVURN 028 model.
3. Package Contents
- One (1) VIVURN 028 Replacement RF Remote Control
4. Setup
4.1 Battery Installation
- Locate the battery compartment on the back of the remote control.
- Slide the battery cover downwards to open it.
- Insert two (2) AAA batteries (not included) into the compartment, ensuring correct polarity (+/-) as indicated inside the compartment.
- Slide the battery cover back into place until it clicks securely.
Image: The rear view of the remote control with the battery cover open, illustrating the correct placement of two AAA batteries.
Note: This remote utilizes Radio Frequency (RF) technology, offering more responsive control without needing to point directly at the elliptical.
5. Operating Instructions
Familiarize yourself with the buttons on your VIVURN 028 replacement remote control:
Image: A clear diagram of the remote control, indicating the function of each button.
- POWER (Red Button): Press to turn the elliptical exerciser On or Off.
- START/STOP: Press to start or stop the exercise program. Can also be used to reset certain functions.
- MODE: Cycles through different program modes (P1, P2, P3) or the Heart Rate (HR) mode.
- DIRECTION: In HR mode, press to switch the pedaling direction (forward or reverse).
- FUNCTION: Press to switch the data displayed on the elliptical's screen (e.g., time, distance, calories).
- SPEED ▲ (Up Arrow): In HR mode, press to increase the speed or resistance level.
- SPEED ▼ (Down Arrow): In HR mode, press to decrease the speed or resistance level.
6. Maintenance
6.1 Battery Replacement
When the remote control's responsiveness decreases or the blue indicator light no longer illuminates, it is time to replace the batteries. Follow the battery installation steps in Section 4.1.
- Always use two new AAA batteries.
- Do not mix old and new batteries, or different types of batteries.
- Remove batteries if the remote will not be used for an extended period to prevent leakage.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Remote not responding to elliptical. | Dead or incorrectly installed batteries. | Replace batteries with new AAA batteries, ensuring correct polarity. |
| Remote light does not turn blue when buttons are pressed. | Low battery power or remote malfunction. | Replace batteries. If issue persists, contact VIVURN customer support. |
| Remote works intermittently. | Weak batteries or interference. | Replace batteries. Ensure no strong electronic devices are causing interference nearby. |
| Remote does not control other elliptical models. | Incompatible model. | This remote is only compatible with the VIVURN 028 White under desk elliptical (ordered after Oct 1, 2025). |
8. Specifications
- Model Name: 028-remote
- Brand: VIVURN
- Item Weight: 1.28 ounces
- Package Dimensions: 6.3 x 5.7 x 0.75 inches
- Power Source: 2 x AAA Batteries (not included)
- Connectivity: Radio Frequency (RF)
9. Warranty and Support
For warranty information or technical support, please refer to the documentation provided with your VIVURN 028 Leg Exerciser or visit the official VIVURN website. Keep your purchase receipt for warranty claims.
