MEETION BTC9770

MEETION Wireless Bluetooth Keyboard and Mouse User Manual

Model: BTC9770

1. Introduction

Thank you for choosing the MEETION Wireless Bluetooth Keyboard and Mouse combo. This ultra-slim, multi-device peripheral set is designed for seamless connectivity across various operating systems, including Windows and Mac. This manual provides detailed instructions for setup, operation, maintenance, and troubleshooting to ensure optimal performance and a comfortable user experience.

MEETION Wireless Bluetooth Keyboard and Mouse Combo

Figure 1: MEETION Wireless Bluetooth Keyboard and Mouse Combo

2. Package Contents

  • 1 x MEETION Wireless Keyboard
  • 1 x MEETION Wireless Mouse
  • 1 x 2.4G USB Receiver (stored in mouse battery compartment)
  • 1 x User Manual

3. Setup Guide

3.1 Battery Installation

The keyboard requires two (2) AAA batteries, and the mouse requires one (1) AA battery. Batteries are not included and must be purchased separately.

  1. Locate the battery compartments on the underside of the keyboard and mouse.
  2. Open the battery covers.
  3. Insert the batteries, ensuring correct polarity (+/-).
  4. Close the battery covers securely.
Battery Installation Diagram

Figure 2: Battery installation for keyboard and mouse.

3.2 Powering On and System Switching

After installing batteries, locate the power switch on the back of the keyboard and the bottom of the mouse. Slide the switches to the ON position.

To optimize compatibility, switch the keyboard to the correct operating system mode:

  • For Windows system: Press Fn + N
  • For Mac system: Press Fn + M
Preparation Steps: Battery, Power, System Switch

Figure 3: Steps for battery installation, powering on, and system mode selection.

3.3 Connecting via 2.4G Wireless Mode

The 2.4G wireless mode uses a USB receiver for connection.

  1. Remove the 2.4G USB receiver from its storage compartment on the bottom of the mouse.
  2. Insert the USB receiver into an available USB port on your computer.
  3. On the keyboard, press the 2.4G button (often indicated by a Wi-Fi symbol). The 2.4G indicator light will illuminate.
  4. On the mouse, click the Mode Switching Button (usually on the bottom) until the 2.4G indicator light turns green.
  5. The keyboard and mouse should now be connected to your device.
2.4G Mode Connection Instructions

Figure 4: Visual guide for 2.4G wireless connection.

3.4 Connecting via Bluetooth Mode (BT1/BT2)

The combo supports two independent Bluetooth connections (BT1 and BT2), allowing you to switch between up to three devices (one 2.4G, two Bluetooth).

  1. On the keyboard, press the BT1 or BT2 key. The corresponding Bluetooth indicator light will turn blue and begin to blink, indicating it's in pairing mode.
  2. On your computer or device, open Bluetooth settings and search for new devices. You should see