K.balt 300-Lumen LED Battery-Operated Handheld Work Light Instruction Manual

Introduction

Thank you for choosing the K.balt 300-Lumen LED Battery-Operated Handheld Work Light. This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your new work light. Please read it thoroughly before use and retain it for future reference.

Image: Angled view of the K.balt 300-Lumen LED Handheld Work Light, showcasing its blue and black rugged design and the COB LED panel.

Safety Information

• Do not look directly into the LED light source to avoid eye injury.
• Keep the work light away from flammable materials.
• Do not attempt to disassemble or modify the light. This will void the warranty and may cause damage or injury.
• Ensure batteries are inserted with correct polarity.
• Remove batteries if the light will not be used for an extended period.
• Dispose of used batteries according to local regulations.

Package Contents

• K.balt 300-Lumen LED Handheld Work Light (Model: 3626913)
• 3 x AA Batteries

Setup

Battery Installation

1. Locate the battery compartment cover, typically at the base or rear of the handle.
2. Open the battery compartment.
3. Insert the 3 AA batteries, ensuring correct polarity (+ and -) as indicated inside the compartment.
4. Close the battery compartment cover securely.

Image: Front view of the K.balt work light, showing the LED panel and power button. The battery compartment is typically located in the handle section.

Operating Instructions

Power On/Off and Dimming

• To turn the light on, press the power button located on the body of the light. The light will illuminate at its maximum brightness (300 lumens).
• To dim the light, press and hold the power button. The brightness will gradually decrease from 300 lumens down to 30 lumens. Release the button at your desired brightness level.
• To turn the light off, press the power button again.

Hands-Free Operation

The K.balt work light offers multiple options for hands-free use:

• Magnetic Base: The base of the light contains strong magnets. Attach the light to any ferrous metal surface for stable positioning. The light can be angled when attached magnetically.
• Pivoting Hook: A pivoting hook is integrated into the design. Extend the hook and hang the light from pipes, wires, or other suitable structures.

Image: A diagram highlighting the key features of the work light: the COB LED panel, the pivoting hook for hanging, and the magnetic base for hands-free attachment to metal surfaces.

Image: Close-up view of the bottom of the work light, clearly showing the four circular magnets embedded in the base for secure attachment.

Maintenance

• Cleaning: Wipe the exterior of the work light with a soft, damp cloth. Do not use abrasive cleaners or solvents.
• Battery Replacement: Replace all three AA batteries simultaneously when the light output diminishes significantly. Ensure new batteries are of the same type and inserted correctly.
• Storage: Store the work light in a cool, dry place when not in use. Remove batteries if storing for extended periods.

This work light is designed to be water and impact resistant, providing durability in various work environments. However, it is not submersible and should not be intentionally exposed to excessive water or severe impacts.

Troubleshooting

Specifications

Warranty and Support

For warranty information or technical support, please refer to the product packaging or contact the manufacturer directly. Keep your purchase receipt as proof of purchase.

Manufacturer: Kobalt