Introduction
This manual provides detailed instructions for the installation, operation, maintenance, and troubleshooting of your WinZo Smart Toilet, model SM8008-2. Please read this manual thoroughly before installation and use to ensure proper function and safety. Keep this manual for future reference.
Figure 1: WinZo Smart Toilet SM8008-2
Safety Functions
The WinZo Smart Toilet is equipped with several safety features to ensure user protection and product longevity.
Figure 2: Overview of Safety Functions
- 110V American Standard: Designed to meet standard electrical requirements.
- High/Low Voltage Protection: Safeguards the unit from electrical fluctuations.
- Flame Retardant Seat: Enhances safety in case of electrical issues.
- IPX4 Waterproof: Provides protection against splashing water.
- Dry Burning Protection: Prevents damage from overheating when water levels are low.
Setup and Installation
Proper installation is crucial for the optimal performance of your smart toilet. It is recommended to have a qualified professional perform the installation.
Pre-Installation Checklist
- Ensure the ground is clean and dry.
- Verify the ground is horizontal using a level.
- Confirm the sewer pipe is unobstructed.
- Measure the rough-in distance (must be ≥12 inches).
- Ensure water pressure is over 0.14Mpa and flow rate is over 18L/min.
Installation Steps
- Prepare the Angle Valve: Wrap the raw material belt around the interface of the foot valve.
- Install the Angle Valve: Securely install the angle valve to the water supply.
- Drain Residual Water: Open the angle valve briefly to drain any residual water.
- Reinstall Constant Flow Valve: Reinstall the constant flow valve into the angle valve.
- Install Flange: Install expansion screws into the flange and mount the flange at the drain, ensuring it is centered.
- Position Toilet: Lift the upper half of the toilet. Align the flange and screws with the bottom of the toilet.
- Secure Toilet: Install the flat washer and nut to secure the toilet to the flange.
- Connect Water Inlet Pipe: Connect the braided tube to the angle valve and the toilet's water inlet. Pay attention not to bend the tube. Open the angle valve to the maximum and check for leaks.
- Power On: Plug the toilet into a suitable power outlet.
Video 1: WinZo Smart Toilet Installation Guide. This video demonstrates the step-by-step process for installing the smart toilet, including preparing the water connection and securing the unit.
Operating Instructions
Your WinZo Smart Toilet offers a range of intelligent features for enhanced comfort and hygiene.
Automatic Functions
- Foot Sensor Operation: The lid and seat automatically open when you approach the toilet and close/flush when you leave.
- Pre-Moistening: The bowl is pre-moistened before use to prevent waste adhesion.
- Auto Flush: Flushes automatically after use.
Figure 3: Auto-Sensing Features
Figure 4: Pre-Moistening Function
Bidet and Drying Functions
- Heated Seat: The seat provides instant warmth with 4 adjustable temperature levels.
- Warm Water Bidet: Offers instant warm water for washing with adjustable temperature.
- Cleaning Modes: Includes Female Cleaning, Hip Cleaning, and Mobile Cleaning.
- Warm Air Drying: After washing, a warm air dryer provides comfort.
Figure 5: Heated Seat Functionality
Figure 6: Multiple Cleaning Modes
Additional Features
- Night Light: A light-sensitive night light illuminates the bowl for nighttime use.
- Remote Control: All functions can be controlled via the included remote.
Figure 7: Soft Night Light Illumination
Video 2: WinZo Smart Toilet Features Overview. This video demonstrates various operational features including cleaning modes, heated seat, and automatic functions.
Maintenance
Regular maintenance ensures the longevity and hygienic operation of your WinZo Smart Toilet.
Cleaning
- Dynamic Cleaning Module: The built-in dynamic cleaning module activates high-frequency short-wave closed irradiation for deep cleaning of the toilet bowl.
- Nozzle Self-Cleaning: The bidet nozzles perform a self-cleaning cycle before and after each use.
- Ultraviolet Spray Bar Sterilization: Automatically turns on UV sterilization after closing the lid for a round scanning to prevent cross-infection.
- Individual Water Line Cleaning: Ensures hygiene by cleaning individual water lines.
Figure 8: Ultraviolet Spray Bar Sterilization
Figure 9: Individual Cleaning of Water Lines
General Cleaning
Use a soft, damp cloth and mild, non-abrasive cleaner for external surfaces. Avoid harsh chemicals that may damage the finish or electronic components.
Troubleshooting
If you encounter issues with your WinZo Smart Toilet, refer to the following common troubleshooting steps:
| Problem | Possible Cause | Solution |
|---|---|---|
| No power/Unit unresponsive | Power cord unplugged, circuit breaker tripped. | Ensure power cord is securely plugged in. Check and reset circuit breaker if necessary. |
| No water for bidet/flush | Water supply valve closed, low water pressure. | Open the angle valve fully. Check household water pressure. |
| Lid/Seat not opening automatically | Foot sensor obstructed or dirty. | Clean the foot sensor area. Ensure no objects are blocking the sensor. |
| Heated seat not working | Heated seat function turned off, temperature setting too low. | Activate heated seat function via remote. Adjust temperature setting. |
| Water leakage | Loose connections in water inlet pipe or angle valve. | Tighten all water connections. If leakage persists, contact customer support. |
For issues not listed here or if troubleshooting steps do not resolve the problem, please contact WinZo customer support.
Specifications
Detailed specifications for the WinZo Smart Toilet SM8008-2.
| Feature | Detail |
|---|---|
| Model Number | SM8008-2 |
| Product Dimensions | 27"D x 15.41"W x 18.9"H |
| Material | Ceramic (Bowl), Plastic (Seat) |
| Item Weight | 98 Pounds |
| Installation Type | Floor Mounted |
| Shape | Oval |
| ADA Compliance | ADA Comfort Height (17'' floor-to-bowl) |
| Water Efficiency | Less than 1.28 gallons per flush |
| Water Pressure Requirement | Over 0.14Mpa |
| Flow Rate Requirement | Over 18L/min |
| Included Components | Smart Toilet |
Figure 10: Product Dimensions
Figure 11: ADA Comfort Height
Warranty and Support
WinZo provides a manufacturer's warranty for this product. For specific warranty details, registration, or technical support, please refer to the warranty card included with your product or visit the official WinZo website. Keep your purchase receipt as proof of purchase.
Contact Information: Please refer to the contact details provided in your product packaging or on the official WinZo website for customer service and support.