AOLIKES 1500mAh Lithium Polymer Battery Replacement

1. Introduction

This manual provides essential information for the safe and effective use of your AOLIKES 1500mAh Lithium Polymer replacement battery. This battery is designed for specific Moonybaby HD Baby Monitor models. Please read these instructions carefully before installation and use to ensure proper function and safety.

2. Safety Information

WARNING!!! Potential for fire or burning.

• Do not disassemble, puncture, crush, heat, or burn the battery.
• Avoid exposing the battery to extreme temperatures (above 60°C / 140°F or below -10°C / 14°F).
• Do not short-circuit the battery terminals.
• Keep the battery away from water or other liquids.
• Store the battery out of reach of children and pets.
• Dispose of used batteries according to local regulations. Do not dispose of in household waste.
• Use only with compatible devices as specified in this manual.

3. Compatibility

This AOLIKES 1500mAh Lithium Polymer battery is compatible with the following Moonybaby HD Baby Monitor models:

• Moonybaby Trust 30 MNB933 (4.3" Screen)
• Moonybaby 55933R (4.3" Screen)
• Moonybaby 55935R (5" Screen)
• Moonybaby 55935BV (5" Screen)
• Moonybaby Low EMF Long Range 5" HD Baby Monitor (5" Screen)

It is also compatible with battery models MNB935, 55935R, 55935bv Split 50, MNB933, 55933R, 55933, Agm nb935rx, 2aagomnb935rx, and 2aagomnb933rx.

4. Installation (Setup)

Follow these general steps to replace the battery in your Moonybaby baby monitor. Refer to your specific monitor's user manual for detailed instructions on accessing the battery compartment.

1. Power Off: Ensure your baby monitor unit is completely powered off and disconnected from any power source.
2. Locate Battery Compartment: Identify and open the battery compartment on your monitor unit. This is typically on the back and may require a small screwdriver.
3. Remove Old Battery: Carefully disconnect the old battery from its connector and remove it from the compartment.
4. Insert New Battery: Connect the new AOLIKES 1500mAh battery to the monitor's battery connector, ensuring the polarity is correct. Gently place the battery into the compartment.
5. Secure Compartment: Close the battery compartment cover and secure it, if applicable.
6. Initial Charge: Connect your monitor to its power adapter and allow the new battery to charge fully before first use.

5. Operation (Charging)

Once installed, the battery will charge automatically when the monitor is connected to its power adapter. For optimal performance and battery longevity:

• Perform an initial full charge before the first use.
• Avoid frequently draining the battery completely before recharging.
• Use only the original or manufacturer-approved power adapter for your Moonybaby monitor.

6. Maintenance

• Storage: If storing the battery for an extended period, ensure it is charged to approximately 50% and stored in a cool, dry place.
• Cleaning: Keep the battery and its contacts clean and dry. Use a soft, dry cloth if cleaning is necessary.
• Avoid Physical Damage: Protect the battery from drops, impacts, and punctures.

7. Troubleshooting

• Battery Not Charging: Ensure the monitor's power adapter is correctly connected and functioning. Verify the battery is properly seated in its compartment and its connector is secure.
• Short Battery Life: Ensure the battery has been fully charged. Environmental factors (extreme cold/heat) or heavy usage can affect battery life. If issues persist, the battery may need replacement.
• Monitor Not Powering On: Confirm the battery is correctly installed and charged. If the monitor still does not power on, consult your Moonybaby monitor's user manual or contact Moonybaby support.

8. Specifications

This image displays the AOLIKES 1500mAh Lithium Polymer battery. The label indicates Model No: Y23ACDAA1, Nominal Voltage: 3.7V, Capacity: 1500mAh, Power: 5.55Wh, and Limited Charge Voltage: 4.2V. Important safety warnings are also visible, advising against disassembly, puncturing, crushing, heating, or burning due to potential fire hazards. The battery is marked 'Made in China' and includes CE, UKCA, and Li-ion disposal symbols.

9. Warranty and Support

For warranty information and customer support, please refer to the documentation provided with your purchase or contact the seller directly. The manufacturer of this battery is AOLIKES.