Introduction
This manual provides essential instructions for the proper use and maintenance of your Generic IR Replacement Remote Control. This remote is designed to operate various Whalen electric firebox heater models. Please read this manual thoroughly before use to ensure optimal performance and longevity of your remote control.
Package Contents
Verify that all items are present in your package:
- 1 x Generic IR Replacement Remote Control
Note: Batteries are not included and must be purchased separately.
Setup
Battery Installation
The remote control requires two AAA batteries for operation. Follow these steps to install the batteries:
- Locate the battery compartment cover on the back of the remote control.
- Gently slide the cover downwards or press the release tab (if present) to open the compartment.
- Insert two AAA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
- Slide the battery compartment cover back into place until it clicks securely.
Image: Back of the remote control, illustrating the battery compartment. Note: The image shows a CR2025 battery, but the product requires AAA batteries. Please follow the AAA battery instructions.
Initial Use
This is an infrared (IR) replacement remote control. No programming or setup is required. Once batteries are installed, the remote is ready for use with compatible Whalen electric firebox heaters.
Operating Instructions
Point the remote control directly at the infrared receiver on your electric firebox heater. Ensure there are no obstructions between the remote and the heater.
Image: Front view of the remote control, displaying its buttons.
Button Functions
| Button Symbol | Function | Description |
|---|---|---|
| Power (⏻) | On/Off | Turns the electric firebox heater on or off. |
| Heat (∣∣∣) | Heat Settings | Adjusts the heat output or cycles through heat levels. |
| Temperature Up (▲) | Increase Temperature | Increases the desired temperature setting. |
| Temperature Down (▼) | Decrease Temperature | Decreases the desired temperature setting. |
| Flame (🔥) | Flame Effect | Controls the flame effect settings (e.g., brightness, intensity). |
| Timer (⏲) | Timer Function | Activates or adjusts the heater's timer function. |
Maintenance
Cleaning
To clean the remote control, wipe it with a soft, dry cloth. Do not use abrasive cleaners, solvents, or wet cloths, as these can damage the remote's surface or internal components.
Battery Replacement
Replace batteries when the remote's range decreases or it stops responding. Always replace both batteries at the same time with new AAA batteries. Do not mix old and new batteries or different types of batteries.
Troubleshooting
- Remote not responding:
- Check if the batteries are installed correctly with the correct polarity.
- Replace the batteries with fresh ones.
- Ensure there are no obstructions between the remote and the heater's IR receiver.
- Confirm that the remote is pointed directly at the heater.
- Short operating range:
- Replace the batteries.
- Ensure the IR receiver on the heater is clean and unobstructed.
- Some functions not working:
- This replacement remote may not offer all functions identical to your original remote. Verify if the desired function is supported by this remote.
- Refer to your heater's original manual for specific remote control compatibility and functions.
Specifications
- Type: Infrared (IR) Replacement Remote Control
- Power Source: 2 x AAA Batteries (not included)
- Compatible Devices: Various Whalen Electric Firebox Heater models (e.g., FP261A, WMFP60EC-7, WSF36SH23M, etc.)
- Color: Black
Warranty and Support
This product is a replacement remote control. For any issues or questions regarding its functionality or compatibility, please contact the seller directly. Keep your purchase information readily available for support inquiries.
