Portwest FR96 Long Sleeve Safety Work T-Shirt User Manual

1. Introduction

Thank you for choosing the Portwest FR96 Long Sleeve Safety Work T-Shirt. This garment is designed to provide superior protection and visibility in hazardous work environments. It combines inherent flame-resistant properties with high-visibility reflective tape, ensuring compliance with safety standards and enhancing wearer safety. This manual provides essential information on the proper use, care, and maintenance of your FR96 T-Shirt to ensure its longevity and effectiveness.

2. Safety Information

The Portwest FR96 T-Shirt is engineered with safety as a priority. Please observe the following:

• Flame Resistance: This garment possesses inherent flame-resistant qualities that will not diminish with washing. It is designed to protect against radiant and convective heat.
• ARC2 Rating: Certified with an ARC2 rating, providing protection against electric arc hazards.
• High Visibility: Features flame-resistant reflective tape for enhanced visibility in low-light conditions, meeting ASTM and ANSI standards.
• CE Certified: This product meets the essential health and safety requirements of European directives.
• Always ensure the garment is worn correctly and is free from damage before entering hazardous areas.
• Do not modify the garment, as this may compromise its protective properties.

3. Product Overview

Figure 3.1: Front view of the Portwest FR96 T-Shirt, showcasing the high-visibility yellow fabric and horizontal and vertical reflective banding on the torso and sleeves.

Figure 3.2: Back view of the Portwest FR96 T-Shirt, showing the reflective stripes continuing across the back for 360-degree visibility.

4. Setup and Wearing Instructions

The Portwest FR96 T-Shirt is ready to wear directly out of the packaging.

1. Inspection: Before each use, visually inspect the garment for any signs of damage, tears, or degradation of the reflective tape. Do not use if damaged.
2. Donning: Put on the T-shirt as you would any long-sleeve shirt. Ensure it fits comfortably and allows for full range of motion without being excessively loose or tight.
3. Layering: This shirt can be worn as a primary layer or over other non-flame-resistant clothing, depending on environmental conditions and specific job requirements. Ensure any underlying garments do not compromise the FR properties or fit.
4. Visibility: Ensure the reflective tape is not obscured by other clothing or equipment to maintain maximum visibility.

5. Care and Maintenance

Proper care extends the life of your Portwest FR96 T-Shirt and maintains its protective qualities.

• Washing: Machine wash cold with like colors. Use a mild detergent. Do not use bleach or fabric softeners, as these can degrade the flame-resistant properties and reflective material.
• Drying: Tumble dry low. Remove promptly. Do not wring. Air drying is recommended to preserve the reflective tape.
• Ironing: Do not iron directly on reflective tape. If ironing is necessary, use a low heat setting and iron on the reverse side of the fabric.
• Storage: Store in a clean, dry place away from direct sunlight and extreme temperatures.
• Inspection: Regularly inspect the garment for wear and tear, especially the reflective tape. Replace the garment if its protective features are compromised.

6. Troubleshooting

Most issues with the Portwest FR96 T-Shirt relate to wear and tear or improper care.

• Reduced Reflectivity: If the reflective tape appears dull or damaged, it may be due to excessive washing, harsh detergents, or physical abrasion. Ensure proper care instructions are followed. If reflectivity is significantly reduced, the garment's safety function is compromised and it should be replaced.
• Fabric Damage (Tears/Holes): Any tears or holes in the fabric can compromise the flame-resistant barrier. Small repairs might be possible with FR-rated thread, but significant damage warrants replacement.
• Shrinkage: While designed to resist shrinkage, extreme washing temperatures can affect fabric integrity. Always wash in cold water.
• Discomfort/Poor Fit: Ensure you have selected the correct size. Refer to Portwest's sizing guide if unsure.

7. Specifications

8. Warranty and Support

For information regarding warranty, returns, or technical support for your Portwest FR96 T-Shirt, please contact Portwest customer service directly or refer to the official Portwest website. Keep your purchase receipt as proof of purchase.

Portwest Official Website: www.portwest.com