1. Introduction
This manual provides instructions for the proper installation, operation, and maintenance of your Asixxsix Automatic Fish Feeder. This device is designed to automatically dispense fish food at set intervals, ensuring your aquatic pets are fed consistently, even when you are away. It is suitable for various types of fish food including flakes, granules, powders, and bars, keeping them fresh and dry.
Figure 1: Asixxsix Automatic Fish Feeder installed on an aquarium, showing its compact design and food reservoir.
2. Setup
2.1 Package Contents
Before proceeding, ensure all components are present:
- 1 x Automatic Feeder Unit
- 1 x Base
- 1 x Bracket (Fixed Clip)
- 1 x Plastic Screw
- 1 x Feed Tank (either 210ml or 80ml, depending on model)
Figure 2: All components included with the Asixxsix Automatic Fish Feeder, laid out for assembly.
2.2 Battery Installation
- Locate the battery compartment on the side of the feeder unit.
- Remove the battery cover.
- Insert two (2) AA batteries (not included) according to the polarity markings inside the compartment.
- Replace the battery cover securely.
Figure 3: Battery compartment with two AA batteries installed, showing proper orientation.
2.3 Mounting the Feeder
The feeder offers two installation methods: a fixed clip for aquarium edges and a fixed base for flat surfaces.
2.3.1 Using the Fixed Clip (Bracket)
- Attach the bracket (fixed clip) to the bottom of the feeder unit.
- Position the clip over the edge of your aquarium.
- Tighten the plastic screw to secure the feeder firmly to the aquarium wall. Ensure it is stable and level.
Figure 4: Feeder attached to an aquarium edge using the fixed clip, showing the tightening screw.
2.3.2 Using the Fixed Base
- Attach the fixed base to the bottom of the feeder unit.
- Place the feeder on a stable, flat surface near your aquarium, ensuring the food dispensing opening is positioned correctly over the water.
Figure 5: The feeder unit with both fixed clip and fixed base options for versatile placement.
2.4 Filling the Feed Tank and Adjusting Volume
- Remove the feed tank from the feeder unit.
- Fill the tank with your desired fish food (flakes, granules, powders, or bars).
- Reattach the feed tank to the feeder unit.
- Locate the feeding volume adjustment switch on the feed tank. Adjust this switch to control the size of the opening, thereby regulating the amount of food dispensed per feeding cycle.
Figure 6: Example of different capacity feed tanks (80ml and 210ml) for varying needs.
3. Operation
The Asixxsix Automatic Fish Feeder features both automatic timing functions and a manual feeding option.
Figure 7: Control panel showing indicator light, manual feeding button, and feeding frequency set buttons (8hr, 12hr, 24hr, 48hr).
3.1 Setting Feeding Frequency
The feeder can be set to dispense food automatically every 8, 12, 24, or 48 hours. To set the frequency:
- Press the corresponding button (8hr, 12hr, 24hr, or 48hr) on the control panel to select your desired feeding interval.
- The indicator light will confirm the selection. The feeder will then dispense food at the chosen interval from the time of setting.
Figure 8: Feeder in operation, demonstrating the control panel for setting feeding times.
3.2 Manual Feeding
To dispense food manually at any time:
- Press the "Manual" button once. The feeder will dispense a single portion of food.
- Note: Repeatedly pressing the "Manual" button during the barrel's rotation will not result in additional immediate feedings. Wait for the current manual feeding cycle to complete before attempting another.
4. Maintenance
4.1 Cleaning
- Regularly check the feed tank and dispensing mechanism for any food residue or moisture buildup.
- To clean, remove the feed tank and wash it with warm water. Ensure it is completely dry before refilling and reattaching to prevent food from clumping.
- Wipe the exterior of the feeder unit with a damp cloth. Do not immerse the main unit in water.
4.2 Battery Replacement
- The feeder is powered by 2 AA batteries, which typically last 2-4 months.
- Replace batteries when the indicator light dims or the feeder stops dispensing food reliably. Refer to Section 2.2 for battery installation instructions.
5. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Feeder does not turn on or dispense food. | Batteries are dead or incorrectly installed. | Check battery polarity and replace with fresh AA batteries. |
| Food is not dispensing or dispensing inconsistently. |
|
|
| Feeder falls off the aquarium. | Mounting screw is loose or not properly secured. | Ensure the plastic screw for the fixed clip is tightened securely to the aquarium wall. |
| Manual feeding button unresponsive during rotation. | This is normal behavior. The feeder needs to complete its current cycle. | Wait for the current manual feeding cycle to finish before pressing the button again. |
6. Specifications
- Model Number: Asixxsixte29xn57oc
- Material: ABS Plastic
- Power Source: 2 x AA Batteries (not included)
- Battery Life: Approximately 2-4 months
- Feeding Frequency: Automatic (8hr, 12hr, 24hr, 48hr), Manual
- Feed Tank Capacity: 80ml (approx. 50g/1.8oz) or 210ml (approx. 100g/3.5oz)
- Product Dimensions: 3.87 x 2.48 x 1.39 inches (L x W x H)
- Item Weight: 866.42 Pounds (Note: This weight appears to be a data entry error and is not representative of the actual product.)
- Operation Mode: Automatic, Manual
- Special Feature: Adjustable feeding volume
- Included Components: Automatic Feeder, Base, Bracket, Plastic Screw, Feed Tank
7. Warranty and Support
For any questions, technical assistance, or support regarding your Asixxsix Automatic Fish Feeder, please contact the seller or refer to the product listing on Amazon for customer service options. While specific warranty details are not provided in this manual, standard consumer rights and return policies apply.
You may also visit the Asixxsix Store on Amazon for more product information.