Rev-A-Shelf RV-35-LID-12-1-40

Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid Instruction Manual

Model: RV-35-LID-12-1-40

Introduction

This manual provides instructions for the proper installation, operation, and maintenance of your Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid. This lid is designed to complement and enhance the functionality of your 35-quart Rev-A-Shelf waste container, helping to contain odors and keep waste out of sight.

Setup

The Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid is designed for simple installation. Align the lid with the top rim of your 35-quart Rev-A-Shelf waste container. Gently press down until the lid snaps securely into place. Ensure all edges are properly seated to create a tight seal.

Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid in Champagne, open position.
This image shows the Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid in its open position, revealing the simple flip-top design. The champagne color is visible.

Operating Instructions

To use the lid, simply lift the flip-top mechanism to access the waste container. After depositing waste, gently push the flip-top back down until it closes. This action helps to contain odors and maintain a tidy appearance. The lid is designed for regular, easy opening and closing.

Side view of the Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid in an open position.
This image provides a side view of the lid in an open position, demonstrating the flip-top functionality.

Maintenance

Regular maintenance ensures the longevity and hygiene of your Rev-A-Shelf lid.

  • Wipe Clean: If the product becomes dirty, handwash with mild soap and water. Wipe dry immediately. Avoid abrasive cleaners, bleach, or harsh chemicals, as these can damage the polymer plastic.
  • Adjust: This lid is a simple snap-on component. Ensure it is always securely snapped onto the waste container. If the fit loosens over time, inspect the container rim for damage or warping.
  • Grease: This product does not require greasing. Do not apply any lubricants to the lid or its hinge mechanism.
Care and Maintenance instructions for Rev-A-Shelf products.
This graphic outlines general care and maintenance tasks for Rev-A-Shelf products, including cleaning and adjustment guidelines.

Troubleshooting

  • Lid does not close properly: Ensure the lid is correctly aligned and fully snapped onto the waste container. Check for any obstructions around the rim of the container or the lid's hinge.
  • Lid detaches easily: Verify that the lid is securely snapped onto the 35-quart Rev-A-Shelf waste container. If the issue persists, ensure the waste container itself is not damaged or warped.
  • Lid interferes with cabinet closure: If the waste container is part of a pull-out system under a cabinet, ensure there is adequate clearance for the lid to open and close without hitting upper drawers or countertops. The lid's highest point when fully open is approximately 11-13/16 inches (279 mm) from the base of the lid.

Specifications

FeatureDetail
MaterialPolymer Plastic
ColorChampagne
BrandRev-A-Shelf
StyleModern
Product Dimensions (L x W x H)0.88"L x 14.13"W x 11.81"H (approx. when closed)
Number of Pieces2 (per pack)
CompatibilityAll Rev-A-Shelf 35-quart waste containers
Item Model NumberRV-35-LID-12-1-40
UPC193802376333
Technical drawing of Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid with dimensions.
This technical drawing provides detailed dimensions for the Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid, including front and side views. Key measurements are indicated for compatibility.
Detailed dimensions for Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid.
Another view of the lid's dimensions, showing the width and height when installed, confirming compatibility with 35-quart Rev-A-Shelf containers.

Warranty

This Rev-A-Shelf product is manufactured with durable, high-quality materials and is designed to last. It is backed by a Lifetime Guarantee, ensuring peace of mind regarding its quality and performance.

Features of Rev-A-Shelf 35 Quart Polymer Plastic Trash Can Replacement Lid, including material, easy cleaning, and lifetime guarantee.
This image highlights key features, including the Rev-A-Shelf Lifetime Guarantee.

Support

For any questions, concerns, or assistance with your Rev-A-Shelf product, please contact customer service:

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.