vidaXL Polygone Freestanding Bicycle Stand for 4 Bikes

1. Introduction

This manual provides instructions for the assembly, operation, and maintenance of your vidaXL Polygone Freestanding Bicycle Stand. This galvanized steel bike rack is designed to securely store up to four bicycles, suitable for both indoor and outdoor use.

2. Safety Information

• Secure Installation: Always fasten the bicycle stand securely to the ground or a stable surface using the provided screws to prevent tipping or falling, especially when bikes are stored.
• Weight Capacity: Do not exceed the stand's capacity of four bicycles.
• Tire Width: Ensure bicycle tires do not exceed 2.2 inches in width to ensure proper fit and stability.
• Children and Pets: Keep children and pets away from the stand during assembly and ensure it is stable before allowing them near it.
• California Proposition 65 Warning: This product may expose you to chemicals known to the State of California to cause cancer or birth defects or other reproductive harm. Wash hands after handling.

3. Package Contents

Please verify that all components are present before beginning assembly. If any parts are missing or damaged, contact vidaXL customer support.

• Galvanized Steel Frame Components (main base, uprights, wheel guides)
• Assembly Hardware (bolts, nuts, washers)
• Mounting Accessories (2 expansion screws, 2 ground screws)
• Instruction Manual

4. Setup and Assembly Instructions

Assembly is required for this bicycle stand. Follow these steps carefully.

4.1 Tools Required

• Wrench or adjustable spanner
• Drill (for ground mounting)
• Measuring tape

4.2 Assembly Steps

1. Unpack Components: Carefully remove all parts from the packaging and lay them out on a clean, flat surface. Check against the package contents list.
2. Assemble Base Frame: Connect the main base sections if they are separate. Ensure all connections are finger-tight before full tightening.
3. Attach Uprights and Wheel Guides: Secure the high and low wheel guides to the base frame using the provided hardware. Pay attention to the high-low position design to ensure correct orientation for handlebar clearance.
4. Tighten All Fasteners: Once all components are in place, securely tighten all bolts and nuts using a wrench. Do not overtighten.
5. Position the Stand: Place the assembled bicycle stand in your desired indoor or outdoor location.
6. Secure to Ground (Recommended): For maximum stability, especially outdoors or in high-traffic areas, use the provided expansion screws and ground screws to anchor the stand to a solid surface. Mark the drilling points, drill pilot holes, and then secure the stand.

Figure 1: Overall dimensions of the bicycle stand, including length (104 cm / 40.9"), width (39.5 cm / 15.6"), height (73 cm / 28.7"), wheel guide heights (30.5 cm / 12" and 20 cm / 7.9"), and tube spacing (5.5 cm / 2.2").

Figure 2: Detail of a secure joint connection, illustrating the assembly method.

Figure 3: Detail of the high-low wheel slot, designed to prevent handlebar tangling.

5. Operating Instructions

Using your vidaXL Polygone Bicycle Stand is straightforward:

1. Positioning Bikes: Roll the front or rear wheel of your bicycle into one of the designated slots. The high-low design allows for efficient parking of multiple bikes by staggering their handlebars.
2. Secure Placement: Ensure the bicycle wheel is fully seated in the slot for maximum stability.
3. Capacity: The stand is designed to hold up to four bicycles.

Figure 4: The fully assembled bicycle stand, showcasing its high-low wheel design for efficient bike storage.

6. Maintenance

To ensure the longevity and optimal performance of your galvanized steel bicycle stand, follow these maintenance guidelines:

• Regular Cleaning: Wipe down the stand periodically with a damp cloth to remove dirt, dust, and debris. For stubborn grime, a mild soap solution can be used, followed by rinsing and drying.
• Inspect Fasteners: Periodically check all bolts, nuts, and screws to ensure they remain tight. Retighten if necessary to maintain stability.
• Galvanized Finish: The galvanized steel finish provides corrosion resistance. Avoid using abrasive cleaners or tools that could scratch or damage this protective layer.
• Ground Anchors: If the stand is anchored to the ground, periodically inspect the ground screws and expansion bolts for any signs of loosening or corrosion.

7. Troubleshooting

8. Specifications

9. Warranty and Support

For warranty information or customer support, please refer to the documentation included with your purchase or visit the official vidaXL website. Keep your purchase receipt for warranty claims.

vidaXL Official Website: www.vidaxl.com