Introduction
This manual provides essential information for the safe and effective use of your new replacement bulbs. Please read this manual thoroughly before installation and retain it for future reference.
These bulbs are designed as a direct replacement for Satco A3662 bulbs, offering 60W power at 130V.
Product Overview
Image: A clear, flame-tip light bulb with a standard screw base. This bulb is designed for general illumination purposes.
The product consists of two replacement bulbs, specifically designed to be compatible with Satco A3662 models. They feature a CA10 bulb shape and operate at 60 watts and 130 volts, providing reliable illumination.
Setup and Installation
- Safety First: Before attempting installation, ensure the power supply to the fixture is turned off at the circuit breaker or fuse box.
- Allow Cooling: If replacing an existing bulb, allow the old bulb to cool completely before handling to prevent burns.
- Remove Old Bulb: Carefully unscrew the old bulb from the socket by turning it counter-clockwise.
- Insert New Bulb: Gently screw the new replacement bulb into the socket by turning it clockwise until it is snug. Do not overtighten.
- Restore Power: Once the new bulb is securely installed, restore power to the fixture.
- Test: Turn on the light switch to confirm the bulb is functioning correctly.
Note: Always handle light bulbs by their base to avoid transferring oils from your skin to the glass, which can reduce bulb life.
Operating Instructions
These bulbs are designed for standard on/off operation via a light switch. They do not require any special operating procedures beyond typical light bulb usage.
- Ensure the bulb is installed in a compatible fixture with the correct voltage (130V).
- The bulbs are rated for 60W. Do not exceed the maximum wattage rating of your light fixture.
- These bulbs are suitable for indoor use.
Maintenance
These replacement bulbs are designed for minimal maintenance. Follow these guidelines to ensure optimal performance and longevity:
- Cleaning: Before cleaning, ensure the power is off and the bulb is cool. Wipe the bulb gently with a soft, dry cloth. Do not use liquid cleaners or abrasive materials.
- Replacement: Replace bulbs when they burn out. The average life of these bulbs is approximately 5000 hours.
- Storage: Store unused bulbs in their original packaging in a cool, dry place to protect them from damage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Bulb does not light up. | No power to the fixture. Bulb not screwed in properly. Bulb has reached end of life. | Check circuit breaker/fuse. Ensure bulb is securely tightened. Replace bulb with a new one. |
| Bulb flickers. | Loose connection. Incompatible dimmer switch (if applicable). | Tighten bulb in socket. Ensure fixture is not on a dimmer if bulb is non-dimmable. |
| Bulb burns out quickly. | Excessive voltage. Frequent on/off cycling. Poor ventilation in fixture. | Verify fixture voltage. Reduce frequency of switching. Ensure adequate airflow around bulb. |
Specifications
| Attribute | Value |
|---|---|
| Product Type | Replacement Bulb |
| Compatibility | Satco A3662 |
| Wattage | 60W |
| Voltage | 130V |
| Bulb Shape | CA10 |
| Average Life | 5000 Hours |
| Condition | New |
| Bulb Base | Flanged |
| Indoor/Outdoor Usage | Indoor |
Warranty and Support
Information regarding specific warranty terms for this product is not provided in the available data. For any product support or warranty inquiries, please contact the seller or manufacturer directly through the platform where the purchase was made.
Manufacturer: Generic
ASIN: B0CX8MSH8W