Motorcycle 12V Reflector Light User Manual

Introduction

This manual provides detailed instructions for the installation, operation, and maintenance of your malemollygebide Motorcycle 12V Reflector Light. Designed for universal fit, this LED light enhances visibility and safety for various vehicles including motorcycles, scooters, ATVs, mopeds, bicycles, and tricycles. Please read this manual thoroughly before installation and use to ensure proper function and safety.

Safety Information

• Always disconnect power before installation or maintenance.
• Ensure proper wiring connections to prevent short circuits or damage to the light or vehicle's electrical system.
• Mount the light securely to prevent detachment during vehicle operation.
• Do not modify the product. Unauthorized modifications may void the warranty and pose safety risks.
• Consult a qualified technician if you are unsure about any installation steps.

Package Contents

Verify that all items are present in the package:

• 1 * Motorcycle Tail Brake Light

Figure 1: Contents of the package, showing the front and rear view of the reflector light.

Specifications

Figure 2: Product dimensions for installation planning.

Installation Guide

1. Mounting the Light

1. Choose a suitable flat surface on your vehicle (motorcycle, scooter, ATV, moped, bicycle, or tricycle) for mounting. The light is designed for rear placement.
2. Ensure the chosen location allows for clear visibility of the light from the rear.
3. The light features a bolt for secure attachment. Drill a hole of appropriate size at the desired mounting point.
4. Insert the bolt through the drilled hole and secure it with the provided nut from the other side. Tighten firmly but do not overtighten to avoid damaging the light or mounting surface.

Figure 3: Rear view of the light, illustrating the mounting bolt and wire connections.

2. Wiring Connections

The light has three wires for multi-functionality:

• Black Wire: Connect to the Negative Pole (Ground) of your vehicle's electrical system.
• Blue Wire: Connect to the Positive Pole for weak light (e.g., running/tail light function).
• Red Wire: Connect to the Positive Pole for strong light (e.g., brake light or turn signal function).

Ensure all connections are secure and insulated to prevent short circuits and water ingress. Test the light functions before final assembly.

Figure 4: Wiring diagram and application examples on various vehicles.

Operating Instructions

Once properly installed and wired, the reflector light will operate based on the electrical signals from your vehicle:

• When the vehicle's running lights are activated, the light will illuminate with a weak intensity (via the blue wire connection).
• When the brake lever/pedal is pressed or the turn signal is activated, the light will illuminate with a strong intensity (via the red wire connection), providing enhanced visibility for braking or signaling turns.

Figure 5: The light is available in various colors, each providing distinct visibility characteristics.

Maintenance

• Regularly inspect the light for any physical damage or loose connections.
• Clean the surface of the light with a soft, damp cloth to remove dirt and debris, ensuring maximum light output and reflection. Do not use abrasive cleaners.
• The LED components are designed for long life and do not require replacement under normal operating conditions.

Troubleshooting

Warranty and Support

For warranty information or technical support, please contact the manufacturer, malemollygebide, through the retailer where the product was purchased. Keep your purchase receipt as proof of purchase.