Introduction
Thank you for purchasing the So Yummy by bella Portable To Go Blender. This manual provides important information for the safe and efficient operation of your new blender. Please read it thoroughly before first use and retain it for future reference.
Important Safeguards
When using electrical appliances, basic safety precautions should always be followed, including the following:
- Read all instructions before use.
- To protect against electrical shock, do not immerse the motor base, USB charging port, or cord in water or other liquids.
- Close supervision is necessary when any appliance is used by or near children.
- Unplug from outlet when not in use, before assembling or disassembling parts, and before cleaning.
- Avoid contact with moving parts.
- Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or has been dropped or damaged in any manner.
- The use of attachments not recommended or sold by the manufacturer may cause fire, electric shock, or injury.
- Do not use outdoors.
- Do not let cord hang over edge of table or counter, or touch hot surfaces.
- Do not place on or near a hot gas or electric burner, or in a heated oven.
- Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any control to "off", then remove plug from wall outlet.
- Do not use appliance for other than intended use.
- Blades are sharp. Handle with care.
- Ensure the lid is securely locked in place before operating the appliance.
- Do not blend hot liquids.
- Do not overfill the blending jar.
Package Contents
- So Yummy by bella Portable To Go Blender (Motor Base with Blade Assembly)
- 16 oz BPA-free Tritan Blending Jar
- Leakproof Lid with Drinking Spout and Carrying Strap
- USB-C Charging Cable
Product Overview
Familiarize yourself with the components of your Portable To Go Blender.
- Motor Base: Contains the motor, battery, and control button.
- Blade Assembly: Integrated into the motor base, features stainless steel blades.
- Blending Jar: 16 oz (473 ml) capacity, BPA-free Tritan material with measurement markings.
- Lid: Leakproof with a drinking spout and carrying strap.
- USB-C Charging Port: Located on the motor base for recharging.
- Power Button: One-button operation for blending and pulsing.
Charging the Blender
Before first use, fully charge the blender. A full charge provides power for up to 30 blends.
- Locate the USB-C charging port on the motor base.
- Connect the provided USB-C charging cable to the port.
- Plug the other end of the USB-C cable into a compatible USB power adapter (not included) or a powered USB port.
- The indicator light on the motor base will illuminate to show charging status. Refer to the indicator light guide for details (e.g., solid red for charging, solid green for fully charged).
- Once fully charged, disconnect the charging cable.
Setup and Assembly
- Ensure the blender is fully charged before initial use.
- Wash the blending jar and lid with warm, soapy water. Rinse thoroughly and dry. The motor base should be wiped clean with a damp cloth.
- Place the motor base on a stable, flat surface.
- Add your desired ingredients into the 16 oz Tritan blending jar. Do not exceed the maximum fill line.
- Securely screw the blending jar onto the motor base, ensuring it is tightly sealed to prevent leaks.
- Attach the leakproof lid to the blending jar.
Operating Instructions
Blending
- After assembling the blender with ingredients, ensure the jar is securely attached to the motor base and the lid is on.
- Press the power button on the motor base once to start blending. The blades will begin to rotate.
- Blend until desired consistency is achieved. For optimal blending, you may gently shake the blender during operation.
- Press the power button again to stop blending.
- Unscrew the blending jar from the motor base and remove the lid to enjoy your blend.
Pulsing
The blender also supports a pulse function for controlled blending.
- To pulse, press and hold the power button. The blades will operate as long as the button is held down.
- Release the button to stop pulsing.
Tips for Best Results:
- Cut ingredients into small pieces (approximately 1 inch or 2.5 cm) before blending.
- Always add liquid ingredients first to ensure smooth blending.
- Do not blend hot liquids.
- Avoid overfilling the jar.
- If the blender stops during operation, it may be overloaded or the battery may be low. Refer to the Troubleshooting section.
Cleaning and Maintenance
Proper cleaning and maintenance will extend the life of your blender.
- Before Cleaning: Always ensure the blender is turned off and disconnected from any charging source.
- Blending Jar and Lid: The 16 oz BPA-free Tritan blending jar and its lid are dishwasher safe (top rack recommended). Alternatively, wash them with warm, soapy water, rinse thoroughly, and dry.
- Motor Base and Blade Assembly:
- Do not immerse the motor base in water or any other liquid.
- Wipe the motor base and the exterior of the blade assembly with a damp cloth.
- For stubborn residue around the blades, carefully use a small brush. Be extremely cautious as the blades are sharp.
- Ensure the charging port is dry before recharging.
- Storage: Store the blender in a clean, dry place.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Blender does not turn on. | Battery is low or depleted. Jar is not securely attached. | Charge the blender fully. Ensure the blending jar is tightly screwed onto the motor base. |
| Blades stop during blending. | Overloaded with ingredients. Ingredients are too large or hard. Battery is low. | Reduce the amount of ingredients. Cut ingredients into smaller pieces. Add more liquid. Charge the blender. |
| Leaking from the jar. | Lid or jar not properly sealed. Overfilled. | Ensure the lid is securely attached and the jar is tightly screwed onto the base. Do not exceed the maximum fill line. |
| Unusual noise or smell. | Motor strain or foreign object. | Stop blending immediately. Check for obstructions. If problem persists, discontinue use and contact customer support. |
Specifications
- Brand: So Yummy by bella
- Model: Portable To Go Blender
- Capacity: 16 oz (473 ml)
- Material: BPA-free Tritan (jar), Stainless Steel (blades)
- Power Source: Battery Powered, USB Rechargeable
- Voltage: 5 Volts (DC)
- Product Dimensions: Approximately 11.43 x 11.43 x 27.94 cm
- Item Weight: Approximately 653 g
- Special Features: Cordless, Portable, One-button operation
Warranty and Support
For warranty information or customer support, please refer to the documentation included with your purchase or visit the official So Yummy by bella website. Keep your proof of purchase for warranty claims.