Chofit Charger Cable for ZOLALAM T21 Smart Watch

Introduction

This manual provides instructions for the Chofit USB portable magnetic charger cable, specifically designed for the ZOLALAM T21 Smart Watch. It covers proper usage, safety precautions, and maintenance to ensure optimal performance and longevity of your charging cable.

Package Contents

• 2 x Chofit USB Charger Cable

Compatibility

This charger cable is designed for use with the ZOLALAM T21 Smart Watch.

Note: While some product listings or specifications may mention compatibility with other models like the Togala P99, users are advised to verify the pin spacing (e.g., 4mm) to ensure proper fit and function, as discrepancies have been reported. This charger is specifically optimized for the ZOLALAM T21.

Setup

1. Unpack the charger cable from its packaging.
2. Identify the USB-A connector and the magnetic charging cradle.
3. Connect the USB-A connector to a compatible power source.

Compatible Power Sources:

• Computer USB port
• Laptop USB port
• USB wall adapter (Note: Must use adapters under 2A to prevent damage from overcurrent.)
• Car USB port

Ensure the power source is stable and provides appropriate voltage.

Operating Instructions

1. Place your ZOLALAM T21 Smart Watch onto the magnetic charging cradle of the cable.
2. Ensure the charging pins on the cable align correctly with the charging contacts on your smartwatch. The magnetic connection will help secure the watch in place.
3. Verify that the watch display indicates it is charging.
4. Once fully charged, carefully remove your smartwatch from the charging cradle.

Charging Environment: The cable is designed for convenient charging at home, in the office, in a car, or during travel.

Safety Information

• Overcurrent Protection: The built-in voltage regulator prevents damage to your watch from overcurrent. Always use USB adapters under 2A.
• Short-Circuit Protection: The cable includes short-circuit protection to safeguard your device.
• Avoid exposing the cable to extreme temperatures or direct sunlight.
• Do not attempt to disassemble or modify the charger cable.
• Keep out of reach of children.
• Disconnect the charger from the power source when not in use.

Maintenance

• Clean the charging pins on the cable and the contacts on your smartwatch regularly with a dry, soft cloth to ensure optimal connection.
• Store the cable in a clean, dry place when not in use.
• Avoid sharp bends or excessive pulling on the cable to prevent damage to the reinforced cable joint and internal wiring.
• The cable is made from durable PC material and soft ABS plastic, designed for longevity and to prevent scratching your watch.

Troubleshooting

Watch Not Charging:

• Check Connection: Ensure the magnetic charging cradle is properly aligned with the smartwatch's charging contacts.
• Power Source: Verify that the USB power source is active and functioning correctly. Try a different USB port or adapter.
• Cable Condition: Inspect the cable for any visible damage. If damaged, discontinue use.
• Clean Contacts: Clean the charging pins on both the cable and the watch to remove any dust or debris that might obstruct the connection.

Slow Charging:

• Power Adapter: Ensure you are using a suitable USB power adapter (under 2A). Lower amperage adapters may result in slower charging.
• Cable Length: While the cable is 1.6ft, using excessively long cables or poor-quality extensions can sometimes affect charging speed.

If issues persist, please refer to the Warranty and Support section for further assistance.

Specifications

Warranty and Support

For warranty information or technical support, please refer to the seller's return policy or contact the manufacturer directly.

• Return Policy: 30 days (refund/replacement) as per seller's policy.
• Manufacturer: Chofit
• Seller: Yileda US (via Amazon)

For further assistance, visit the Chofit Store on Amazon.