Dornbracht Single Lever Mixer Pull-Down with Spray Function

1. Introduction

This manual provides essential information for the installation, operation, and maintenance of your Dornbracht Single Lever Mixer Pull-Down with Spray Function, Model META Square 33870861 Chrome. Please read this manual thoroughly before installation and use to ensure proper function and longevity of your product.

Figure 1: Dornbracht META Square Single Lever Mixer Pull-Down Faucet.

This image displays the Dornbracht META Square kitchen faucet, featuring a sleek chrome finish, a single lever handle for water control, and a pull-down spray head. The design is modern and minimalist, suitable for contemporary kitchen environments.

2. Safety Information

Always observe the following safety precautions during installation and operation:

• Ensure the main water supply is turned off before beginning any installation or maintenance work.
• Wear appropriate personal protective equipment (PPE), such as safety glasses and gloves.
• If you are unsure about any part of the installation process, consult a qualified plumber.
• Do not use abrasive cleaners or harsh chemicals on the faucet's finish, as this may cause damage.
• Verify all connections are secure and watertight to prevent leaks.
• This product is designed for kitchen use. Do not use it for purposes other than its intended function.

3. Package Contents

Carefully unpack the product and verify that all components are present and undamaged. The package should include:

• Dornbracht Single Lever Mixer (Faucet Body)
• Pull-Down Spray Head
• Mounting Hardware (nuts, washers, gaskets)
• Hot and Cold Water Supply Lines
• Counterweight for Pull-Down Hose
• Valve (included component)
• Installation Instructions (this manual)

4. Setup and Installation

The Dornbracht META Square faucet is designed for single-hole, deck-mount installation. Follow these general steps for installation. Refer to the technical drawing for precise measurements and component placement.

Figure 2: Technical Drawing with Dimensions.

This diagram provides detailed technical specifications and dimensions for the Dornbracht META Square faucet, including height, reach, mounting hole diameter (35mm or 1 3/8 inches), and connection sizes (G 3/8 for water lines, M 12x1 for mounting rod). It shows both front and side views with measurements in millimeters and inches, crucial for proper installation planning.

1. Prepare the Mounting Surface: Ensure the sink or countertop has a single mounting hole with a diameter of approximately 35mm (1 3/8 inches). Clean the area around the hole.
2. Install the Faucet Body: Insert the faucet body through the mounting hole. From underneath the sink, secure the faucet using the provided washer and mounting nut. Tighten firmly but do not overtighten.
3. Connect Water Supply Lines: Attach the hot and cold water supply lines to the corresponding inlets on the faucet body. Connect the other ends to your hot and cold water shut-off valves. Ensure all connections are hand-tightened, then use a wrench for a final quarter-turn, being careful not to strip threads.
4. Install the Pull-Down Hose and Counterweight: Feed the pull-down hose through the faucet spout. Attach the counterweight to the hose at the specified location (refer to the technical drawing or separate quick-start guide for optimal placement) to ensure smooth retraction of the spray head.
5. Check for Leaks: Once all connections are made, slowly turn on the main water supply. Inspect all connections for any signs of leaks. Tighten any leaking connections as necessary.
6. Flush the System: Remove the spray head and turn on the water to flush out any debris from the lines. Let the water run for a few minutes. Reattach the spray head.

5. Operating Instructions

Your Dornbracht Single Lever Mixer is designed for intuitive operation:

• Water Flow and Temperature: The single lever handle controls both water flow and temperature.
  • Lift the lever upwards to increase water flow. Push it downwards to decrease flow and turn off the water.
  • Move the lever to the left for hot water and to the right for cold water. Adjust the position between left and right to achieve the desired temperature.
• Pull-Down Spray Function:
  • Gently pull the spray head downwards from the spout to extend the hose.
  • The spray head typically has a button or switch to toggle between stream and spray modes. Press this button to select your desired water delivery.
  • When finished, guide the spray head back into the spout. The counterweight will assist in its smooth retraction.

6. Maintenance and Care

Proper care will preserve the beauty and functionality of your Dornbracht faucet:

• Cleaning the Finish: The faucet features a durable Chrome Polished finish. Clean regularly with a soft cloth and mild soap and water. Rinse thoroughly with clean water and dry immediately to prevent water spots.
• Avoid Harsh Cleaners: Do not use abrasive cleaners, scouring pads, ammonia-based cleaners, bleach, or other harsh chemicals, as these can damage the finish and internal components.
• Aerator Maintenance: If water flow becomes restricted, the aerator may be clogged. Unscrew the aerator from the tip of the spout, clean any debris, and rinse it before reattaching.
• Hose Inspection: Periodically inspect the pull-down hose for any signs of wear or kinks.

7. Troubleshooting

Refer to the table below for common issues and their solutions:

If the problem persists after attempting these solutions, please contact Dornbracht customer support or a qualified plumber.

8. Specifications

9. Warranty and Support

Dornbracht stands behind the quality of its products. This faucet comes with a lifetime warranty, ensuring peace of mind regarding manufacturing defects and material integrity.

For technical assistance, replacement parts, or warranty claims, please contact Dornbracht customer support. When contacting support, please have your model number (33870861-00) and purchase information readily available.

You can find contact information on the official Dornbracht website or through your authorized dealer.