vidaXL Reclining Massage Armchair Model 342420 User Manual

Introduction

Thank you for purchasing the vidaXL Reclining Massage Armchair. This manual provides essential information for the safe and efficient use of your new armchair. Please read these instructions carefully before assembly and use, and retain them for future reference.

Image: The vidaXL Reclining Massage Armchair in blue velvet, shown in an upright position within a living room environment.

Safety Instructions

• Ensure all parts are present and undamaged before assembly. Do not use if any parts are missing or broken.
• Keep children and pets away during assembly. Small parts can be a choking hazard.
• Place the armchair on a flat, stable surface.
• Do not stand on the armchair or use it as a step stool.
• Avoid exposing the armchair to direct sunlight or extreme temperatures to prevent material damage.
• For the massage function, use only a certified 5V USB power supply (not included). Do not use unapproved power sources.
• Do not immerse the armchair or its electrical components in water.
• Consult a doctor before using the massage function if you have any medical conditions.

Package Contents

Before beginning assembly, please verify that all components listed below are present in your package.

• Armchair components (backrest, seat, armrests, base)
• Assembly hardware (screws, bolts, washers, Allen key)
• Remote control for massage function
• USB cable for massage function
• Instruction manual

Setup and Assembly

Assembly is required for this armchair. Follow these steps carefully. It is recommended to have two people for assembly.

1. Unpack all components: Carefully remove all parts from the packaging and lay them out on a soft, clean surface to prevent scratches.
2. Attach the backrest: Align the backrest with the seat base and slide it into the designated slots until it clicks securely into place.
3. Secure the armrests: Attach the armrests to the sides of the seat using the provided hardware. Ensure all screws are tightened firmly.
4. Install the legs/feet: Screw the legs or feet into the pre-drilled holes at the bottom of the armchair.
5. Final check: Ensure all connections are secure and the armchair is stable before use.

Image: Dimensional diagram of the armchair, illustrating its height, width, and depth in both upright and fully reclined states.

Operating Instructions

Manual Reclining Function

The armchair features a manual reclining mechanism with 3 adjustable positions.

1. To recline: Lean back firmly against the backrest while pushing forward on the armrests. The backrest will recline, and the footrest will extend.
2. To return to upright position: Lean forward and push the footrest down with your legs. The backrest will return to its original position.

Image: Visual representation of the armchair's reclining motion, demonstrating the extension of the footrest and backward tilt of the backrest.

Vibration Massage Function

The armchair is equipped with a 6-point vibration massage system controlled by a remote.

1. Power Connection: Locate the USB cable for the massage function, typically found in a side pocket or under the seat. Connect it to a certified 5V USB power supply (not included) and plug the power supply into an outlet.
2. Using the Remote Control:
   • Press the red power button to turn the massage function ON/OFF.
   • Use the MODE button to cycle through different massage programs (1-5).
   • The buttons labeled I, II, III control the intensity levels of the massage.
   • The wave symbols indicate different vibration patterns.
3. Massage Zones: The 6 massage points are strategically placed to target different areas of your back and seat.

Image: Side view of the armchair, highlighting the integrated side pocket where the USB cable for the massage function is located.

Image: The remote control for the massage function, detailing its buttons and indicators for program and intensity selection.

Maintenance

• Cleaning the Velvet Fabric:
  • For light dust, use a soft brush or vacuum cleaner with an upholstery attachment.
  • For spills, blot immediately with a clean, dry cloth. Do not rub.
  • For stubborn stains, use a mild upholstery cleaner following the product instructions. Test on an inconspicuous area first.
  • Do not use harsh chemicals or abrasive cleaners.
• Frame Care: Wipe the metal and wood components with a damp cloth and mild detergent if necessary. Dry thoroughly.
• Electrical Components: Keep the USB cable and remote control dry. Do not attempt to repair electrical components yourself.
• Regular Checks: Periodically check all screws and bolts to ensure they remain tight. Retighten if necessary.

Image: Detailed view of the blue velvet fabric, highlighting its texture and quality.

Troubleshooting

Specifications

Warranty and Support

For information regarding warranty coverage, returns, or technical support, please refer to the retailer's policy or contact vidaXL customer service directly. Keep your purchase receipt as proof of purchase.

You can find more information and contact details on the official vidaXL website or through your point of purchase.