EtliN Side Brush Instruction Manual for Cecotec Conga 1290 and 1390 Robotic Vacuum Cleaners

1. Introduction

This manual provides instructions for the installation and maintenance of EtliN replacement side brushes, designed for use with Cecotec Conga 1290 and Cecotec Conga 1390 robotic vacuum cleaners. Regular replacement of side brushes helps maintain the optimal cleaning performance of your robotic vacuum.

2. Compatibility

These replacement side brushes are compatible with the following robotic vacuum cleaner models:

• Cecotec Conga 1290
• Cecotec Conga 1390

Please verify your vacuum cleaner model before installation to ensure proper fit and function.

3. Package Contents

Your package contains the following items:

• 8 x EtliN Replacement Side Brushes

Image 1: Overview of eight EtliN replacement side brushes. Each brush features three gray bristles attached to a teal-colored base.

4. Installation Instructions

Follow these steps to replace the side brushes on your Cecotec Conga robotic vacuum cleaner:

1. Power Off: Ensure your robotic vacuum cleaner is powered off and disconnected from its charging base before beginning any maintenance.
2. Access Brushes: Carefully turn the robotic vacuum cleaner upside down to expose the underside where the side brushes are located.
3. Remove Old Brushes: Locate the existing side brushes. They are typically held in place by a single screw. Use a screwdriver (not included) to unscrew and remove the old, worn-out brushes.


Image 2: Top and bottom views of an EtliN side brush, highlighting the screw attachment point and the square shaft for secure fitting.

4. Install New Brushes: Align a new EtliN side brush with the corresponding attachment point on the vacuum cleaner. Ensure the square shaft on the brush base fits correctly into the vacuum's motor shaft.

Image 3: Close-up of the bottom of an EtliN side brush, illustrating the square attachment mechanism for precise installation.
5. Secure Brushes: Reinsert the screw and tighten it gently to secure the new side brush in place. Do not overtighten.
6. Repeat: Repeat the process for the other side brush if your model has two.
7. Verify: Once both brushes are installed, gently spin them by hand to ensure they are securely attached and can rotate freely.
8. Power On: Turn the robotic vacuum cleaner right-side up and power it on.

5. Maintenance

To ensure optimal cleaning performance and extend the lifespan of your robotic vacuum cleaner, it is recommended to:

• Inspect Regularly: Periodically check the side brushes for wear, damage, or tangled hair/debris.
• Clean Brushes: If brushes are tangled, carefully remove any hair or debris using scissors or a cleaning tool.
• Replace Periodically: For best results, side brushes should be replaced every 2-3 months, or sooner if visible wear or damage occurs. This frequency may vary depending on usage and environment.

6. Troubleshooting

If you encounter issues after replacing the side brushes, consider the following:

• Brushes Not Spinning:
  • Ensure the brushes are correctly aligned and securely screwed into place.
  • Check for any obstructions (e.g., hair, debris) preventing rotation.
  • Verify the vacuum cleaner is powered on and functioning correctly.
• Reduced Cleaning Performance:
  • Confirm the brushes are not excessively worn.
  • Ensure other vacuum components (main brush, filter) are also clean and in good condition.

7. Specifications

Note: Dimensions and weight are approximate and may refer to the package or individual items.

8. Warranty and Support

For any questions regarding the EtliN replacement side brushes or for support, please refer to the retailer or manufacturer's contact information provided at the point of purchase. Keep your purchase receipt for warranty claims, if applicable.