1. Introduction
This manual provides essential instructions for the safe and effective use of your Aicevoos FC-Rechargeble Natural Gas Detector. This device is designed to detect the presence of various combustible gases, including natural gas and propane, in residential and recreational vehicle environments. Please read this manual thoroughly before operating the device and retain it for future reference.
2. Safety Information
WARNING: This device is a gas leak detector and not a substitute for proper gas appliance maintenance or professional gas leak detection services. Always prioritize your safety. If you suspect a significant gas leak, evacuate the area immediately, contact your gas provider, and do not attempt to locate the leak yourself.
- Do not expose the device to extreme temperatures, humidity, or corrosive environments.
- Keep the device away from water and other liquids.
- Do not attempt to disassemble or modify the device. This will void the warranty and may cause malfunction.
- Ensure the device is fully charged before use to maintain optimal performance.
- Perform regular checks as described in the Maintenance section.
3. Product Overview
3.1. Features
- High-sensitivity sensor for various combustible gases (natural gas, propane, methane, ethane, etc.).
- Rapid response time of approximately 0.5 seconds.
- Flexible 14-inch sensor neck for reaching confined spaces.
- Audible and visual alarm indicators.
- LCD display showing gas concentration, ambient temperature, and humidity.
- Rechargeable lithium-ion battery (3.7V).
3.2. Device Components

- LCD Display: Shows gas concentration, temperature, humidity, and other status indicators.
- Gas Sensor Head: Located at the end of the flexible probe, detects gas.
- On/Off Button: Powers the device on or off.
- Mode Key: Cycles through different display modes or settings.
- Unit Selection Button: Changes the unit of measurement for gas concentration (e.g., %LEL, ppm).
- Charging Port: USB port for recharging the internal battery.
- Piezo Buzzer: Emits audible alarm sounds.
- Charging Indication Lamp: Indicates charging status.

4. Setup
4.1. Charging the Device
The device is powered by an internal 3.7V rechargeable lithium-ion battery. Before first use, or if the battery indicator is low, charge the device using the provided USB cable.
- Connect the USB charging cable to the device's charging port.
- Connect the other end of the USB cable to a standard USB power adapter (not included) or a computer USB port.
- The charging indication lamp will illuminate during charging. It will change color or turn off when charging is complete.

4.2. Powering On/Off
Press and hold the On/Off button for a few seconds to power the device on or off.
4.3. Initial Warm-up and Calibration
Upon powering on, the device will undergo a warm-up period of approximately 20 seconds. During this time, ensure the device is in a clean, gas-free environment to allow for proper calibration to a zero baseline. The display will show a countdown or indicator during this process.
5. Operating Instructions
5.1. Gas Detection Process
- After the warm-up period, the device is ready for use.
- Direct the flexible sensor head towards the area where a gas leak is suspected. Move the sensor slowly along pipes, connections, and appliance surfaces.
- Observe the LCD display for gas concentration readings. The device will show values in units such as %LEL (Lower Explosive Limit) or ppm (parts per million), depending on the selected unit.
- The device will emit an audible alarm and provide a visual indication on the LCD when the gas concentration reaches a preset alarm threshold. The alarm intensity may increase with higher gas concentrations.

5.2. Interpreting Alarms
The device features both audible beeps and visual indicators (on the LCD) to alert you to gas presence.

A rising gas concentration reading and an active alarm indicate the presence of combustible gas. The higher the reading and the more frequent/intense the alarm, the greater the concentration of gas detected.
5.3. Unit Selection
Use the 'UNIT' button to cycle through available measurement units for gas concentration, typically %LEL and ppm.
5.4. Applicable Scenarios
The Aicevoos FC-Rechargeble Natural Gas Detector is suitable for detecting leaks in various locations:
- Gas pipelines and connections.
- Gas appliances (stoves, ovens, water heaters).
- RV propane tanks and associated lines.
- Areas where coal gas or other combustible gases might be present.

6. Maintenance
- Cleaning: Wipe the device with a soft, dry cloth. Do not use abrasive cleaners or solvents. Ensure the sensor head is kept clean and free of debris.
- Battery Care: Recharge the battery when the low battery indicator appears. Avoid fully discharging the battery frequently to prolong its lifespan. If storing the device for an extended period, charge it periodically.
- Storage: Store the device in a cool, dry place, away from direct sunlight and extreme temperatures.
- Sensor Protection: The flexible sensor neck is durable, but avoid excessive bending or sharp angles that could damage internal wiring.
7. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not power on. | Battery is depleted. | Charge the device fully using the USB cable. |
| No gas detection or inconsistent readings. |
|
|
| Alarm sounds continuously in clean air. | Sensor may be contaminated or requires recalibration. | Power off the device, move to a known clean air environment, and power on again to allow for proper warm-up and baseline calibration. If the issue persists, contact customer support. |
| Display is dim or unreadable. | Low battery. | Recharge the device. |
8. Specifications
| Feature | Specification |
|---|---|
| Brand | Aicevoos |
| Model Number | FC (Style: FC-Rechargeble) |
| Detection Range | 0-100% LEL |
| Resolving Power | 0.1% LEL |
| Response Time | Approximately 0.5 seconds |
| Sensor Neck Length | 14 inches |
| Power Source | Rechargeable 3.7V Lithium-ion Battery |
| Alarm Type | Audible and Visual |
| Display | LCD with gas concentration, temperature, humidity |
| Item Weight | 1.54 pounds (0.7 kg) |
| Package Dimensions | 9.65 x 4.92 x 2.13 inches |
9. Warranty and Support
Aicevoos products are designed for reliability and performance. For warranty information, technical support, or service inquiries, please refer to the contact information provided with your product packaging or visit the official Aicevoos website. Please have your model number (FC-Rechargeble) and purchase date available when contacting support.